Advice for DID

[Brian]

one and a half centimetres is more than enough to just see through.

Us men could drive a bleeding bus through a gap that big Its almost 3/4 of an inch!

[johnboy]

Sept 25, 2012 16:47:46 GMT Sandra (aka Chillax) said:

Wait a sec John, which, end are you talking of? The 510 connection end or the other end with the screws on?

Sandra the 510 conection.

[johnboy]

Sept 25, 2012 16:49:15 GMT Brian said:

one and a half centimetres is more than enough to just see through.

Us men could drive a bleeding bus through a gap that big Its almost 3/4 of an inch!

No No No Brian mm (OPPS)

[Brian]

aaaaaaaahhh.... well the gap is so small its nothing to be too concerned about.

I`ll leave it to the DID experts for the other stuff

[johnboy]

Vapers , Pushed it down on flat surface again and Bingo she went in and screwed the locking nut up tight, Now only a very tiny gap between the two devices. will try to take a pic so you can compare with yours. Panic may be over.

[Sandra (aka Chillax)]

#icon_welldone# Glad to hear John #icon_thumbsup#

[johnboy]

Sandra, It is now vaping a lot better and i think it can only improve as the coil beds in
Thanks for your help everyone.

#icon_thumbsup#

[Sandra (aka Chillax)]

John if your wondering about the hole, get a bit of tape and cover it, put the smallest pinhole in it, take a vape, then make it a little bigger, vape, it will give you a good idea if you would prefer it drilled out or left alone

[johnboy]

Good thinking that, will do.