Any Spheroid experts please?

[lobeydosser]

I could see the point of it not working the way it is advertised if I was using other makes or type of filler or different wicks or wires, but I am using all the stuff that came with the Spheroid and it still lasts under an hour before going dry.

I just don't understand what is going on.

[Skwoddy]

lol Lobey, it must be very foggy where you are, how do you see your Keyboard?

[lobeydosser]

Och I have to dig it out from under this snowdrift.

[dave]

Like blakey says, the juice capacity depends on how dense the filler is, so the first thing to try is just pulling some of the filler out - I've found this also improves the wicking. Of course if you go too far you will flood it. In the end though it only takes a minute to top them up and for the flavour and hit you get with them well worth it I'd say

[blakey]

They do produce when they're set up well I must admit

[Mev]

I use the Juwel pads and 50mm is a good length for those i've found and i'll fill twice a day. I also put the coil across the hole between the posts and use a doubled 3mm wick.
I like the performance of the Spheroid but i'm not impressed with the connectors, i'm sure there could be a better design.

[Deleted]

Jan 13, 2013 16:44:49 GMT Sandra (aka Chillax) said:

Jan 13, 2013 16:43:44 GMT @ashmal said:

mine drinks juice like buggery as well

What, every hour you have to fill it?

yep sometimes - hard to tell cos I alternate and after some leaks am a bit paranoid about overfilling. I also vape on mech mods at around 1.3 ohm so am probably burning it up quickly :-)

[lobeydosser]

I have just changed my filler over from that that was supplied, to the blue stuff from Paradise Vape.

I will report back later as to how I am doing with it, but so far there is a helluva an improvement on the flavour.

[lobeydosser]

Jan 13, 2013 14:17:00 GMT blakey said:

Yep, the dry hits will cause the burning, I was just pointing out. Try reducing your foam content down to two wraps and see how you get on. I use the paradise vape stuff.

When you say two wraps, do you mean twice round the central pole or do you mean two pieces of the blue material?
(the stuff from Paradise Vape).

[blakey]

Jan 13, 2013 19:14:09 GMT lobeydosser said:

Jan 13, 2013 14:17:00 GMT blakey said:

Yep, the dry hits will cause the burning, I was just pointing out. Try reducing your foam content down to two wraps and see how you get on. I use the paradise vape stuff.

When you say two wraps, do you mean twice round the central pole or do you mean two pieces of the blue material?
(the stuff from Paradise Vape).

Twice round the pole

[lobeydosser]

Okay, I tried that and it leaked.

I have now used one complete (cut to size lengthwise) piece of the blue stuff and tightened everthing up.

So far no leaks, but I will report back later.

[blakey]

You did wrap loose and not pull tight?
I had to chop a bit off from two wraps

[lobeydosser]

Success!
One width of the blue foam, wrapped tight to begin with but looser as I passed the halfway point.
I'm not sure how much juice I put in but it is vaping great and is still going strong at 11pm, having started about 7.30pm.
This is the Spheroid that I had hoped it would be when I bought it.
#icon_thumbsup#