Converting VTR to Mech

[enagee]

Well i seem to be on a looser all ways with the faulty vtr ...so thinking of trying ti converting it to a mechanical mod... so before i start anyone got any ideas or think of any problems there could be in doing this.
All input greatly appreciated.

[markm]

Converting to a true Mech would be tricky, it might be easier to use wires and
make it a simple unregulated device.

[enagee]

Oct 16, 2014 17:59:34 GMT markm said:

Converting to a true Mech would be tricky, it might be easier to use wires and
make it a simple unregulated device.

Yeah thats what i thought...for the firing

[Dan]

markm

how difficult do you think it would be to fit an sx350 chip in the vtr?

I kniw the adjuster wheel at the top would become useless and the firing button would likely need replacing to take full advantage of the chip's capabilities, but is it realistically doable?

[markm]

Not taken a VTR apart to see how much space there is to play with, there is only
One way to find out.

[Dan]

Oct 17, 2014 19:33:38 GMT markm said:

Not taken a VTR apart to see how much space there is to play with, there is only
One way to find out.

I haven't got the gonads or knowhow.. it works at the minute so I'm not going to rip it apart and potentially bugger it up..

I know that the dna20 and dna30 boards fit..

Have a read of this

There is also talk of an sx350'd vtr by SupaVape but their website has been taken down..

Question I ask though, is how much would it cost for someone such as yourself to do it?

(Inclusive of parts)

[markm]

Oct 17, 2014 23:33:46 GMT Dan said:

Oct 17, 2014 19:33:38 GMT markm said:

Not taken a VTR apart to see how much space there is to play with, there is only
One way to find out.

I haven't got the gonads or knowhow.. it works at the minute so I'm not going to rip it apart and potentially bugger it up..

I know that the dna20 and dna30 boards fit..

Have a read of this

There is also talk of an sx350'd vtr by SupaVape but their website has been taken down..

Question I ask though, is how much would it cost for someone such as yourself to do it?

(Inclusive of parts)

Garry Dibley is looking for projects

[enagee]

Watching with interest