for all nickel wire users

[igual]

Nickel wire tends to be softer than kanthal, so this might be of use
www.vape-atomizer-mesh.com/products/Hard-Finish---NI200-Wire---99.6--Nickel---Hard-Drawn.html
Being hard drawn its stiffer and slightly more springy.

[archiecat]

This stuff may lure me back into temp control!

I gave up with the soft nickel, not so bad to set up, but found it very difficult to change the wick without destroying the coil, and a new coil for every wick is to much of a pain for me.

[VapingBad]

I find thin twisted is really easy to work with as the twisting has a similar effect as the tempering, did a dual 3 mm coil genesis with a single piece twisted 0.16 mm 0.12 ohm yesterday and it was a doodle one of the quickest genesis builds I have ever managed with any wire not a single hot spot or short even at 40 W. I would rather get tempered from StealthVape than spend money with VM co as they are vapers and know what they are doing plus the have good customer service.

[Tom]

Same goes for using single strands.

Stick one end in the drill, one end in the pliers.

Spin till it breaks.

You have yourself a stiffened piece of nickel wire

[enjay]

Don't know about that particular wire but 20G nichrome doesn't feel any easier to work with lol