HELP !!!!! guys realy need to get a brass tank ?

[banditruss]

hi guy been looking and looking but cant find any brass tanks (perf sub ohm) only found kraken but fasttech say it wont sub ohm (yet the original will do 0.4),seen a brass bell housing for kayfun(only tank ive not got ..sold mine) but they dont do it for the v4 and its still more stainless than brass (and i dont know if it will sub ohm)
any ideas ?
cheers russ

[thatguy]

The kraken will happily sub ohm. Build mine from 0.2-0.5 constantly.

[DiscoDes]

I don't think Brass is recommended if can come into contact with Vaping juices as it could contain lead (2%) and MAY leech into the liquid.

[banditruss]

kraken has glass sleeve no no probs there .. thatguy is yours a clone and where did you get it from ? cheers

[glen]

May 22, 2015 11:39:28 GMT banditruss said:

kraken has glass sleeve no no probs there .. thatguy is yours a clone and where did you get it from ? cheers

M vapes has kraken sleeves In brass, matt and polished, on the sale items page

[banditruss]

thanks glen ..can get from fastech as well..just needed to if both the 22m and 28mm fasttech versions would sub ohm

[phtumshk]

Ive recently done a Kfun over with a blow torch, you might be able to get 1 to a golden colour like brass.
I could only get to the choclate colour at 500c with a standard blow torch, was aiming for grey/blue.
Was a bit gutted I couldnt get the insulator out of the base to do that too, Im looking to see if you can get the insulators as spares.

these are the possible colour changes but its a bit of an art.

[banditruss]

ohhh thats interesting

[thatguy]

banditruss , our krakens are this one with brass sleeve .

spares are available as well

spare glass
spare o rings and these ones as well
spare screws

WE've not needed the spare orings or screws yet as the ones supplied are great, but it doesn't hurt to have spares around.

[banditruss]

ahh thats good the copper 1 was was looking is the same unit different sleeve i asked fastech they said same unit same manufacturer so thats all good makes me fell better about ordering them...been holding of on a $150 blow out with them

[banditruss]

just a note to say that even though fasttech said their copper kraken was same unit,same manufacturer,they now say the spare don't fit,only fit the SKU 1530400(s/s sleeve) so had to order that one with spares and just brass sleeve no copper sleeve,so then had to get the infinite clone off ebay just to get a copper sleeve are well aleast i ended up with 2 units,well 3 because i ordered the 28mm kraken from fasttech as well lol...id better bloody like em or they'll be in the classifieds...well after the probable 3 week delivery anyway ! so just a note to other prospective buyers of fasttech kraken be careful which one you go for