Goblin looks like it will leak?

[collie2011]

Just received this from fasttech Goblin mini styled RDA

The airflow holes are underneath and straight through to where the cotton is with nothing between the airholes and the mod. Is this right? I'll try to upload pictures to explain what I mean.

[ginge7289]

yep thats right, just make sure your coils are as close to the posts as possible and you have enough cotton in the juice channels. It works great, but you do get a bit of condensation on the top of the 510.

[babs]

I have 2 of these goblin mini's collie2011 once you get used to wicking it it has no problems. I make a single coil and use the adaptor. For wicking I find that if you cut it to edge of the deck no need to push into the juice channel as the bottom chimney will push it into place. If you use the single coil adaptor that also only needs to be placed over the second air slot as the chimney again pushes it into place. It took me a few tries to get it right put once you've cracked it it's a great little thing.

[hijack]

Its the same with the standard goblin, you just need to get enough wick in the top half of the channels and it will prevent any leaks. Dont go overboard as you will 'choke' the wick when you screw the top on. After a few goes you'll have it sussed.

[decoy]

works well
30 mins in is where he starts wicking it
i think the thing that helps the leaks most is the proding about with the wick

[collie2011]

My brain is fried tonight from trying to sort the Zephyrus unsuccessfully. I'm going to give this a try tomorrow.

Sent from my Nexus 7 using proboards

[collie2011]

I think I have it sorted!

[decoy]

you will get a lot of condensation under the atty
just rem to take the atty of and wipe it every so often