WISMEC PRESA TEMPERATURE CONTROL QUESTION

[paulbee]

Hi all



Have had some SS 316L delivered from stealthvape, great service and fast delivery!



Question is can I use it on the Wismec 40W, it only has TC settings for Ni & Ti? I'm assuming not to be on the safge side but thought I would ask just in case.



Thanks



Paul

[Bob]

Feb 11, 2016 18:48:39 GMT paulbee said:

Hi all



Have had some SS 316L delivered from stealthvape, great service and fast delivery!



Question is can I use it on the Wismec 40W, it only has TC settings for Ni & Ti? I'm assuming not to be on the safge side but thought I would ask just in case.



Thanks



Paul

First of all, SS316L can be used in non-TC mode, but according to Steam-Engine for a Ni type mod then if you normally vape at 450F you are supposed to reduce the temp to 150F, but nearly all TC mods only go down to 200F - I do have a DNA40 (TC Nickel only mod) that I have a Uwell Crown (pre-built SS coil head) on top and that works fine set at 30w/200F

[paulbee]

Thanks Bob, I knew it could be used in non TC but from what I've read the flavour is miles better in TC, do you find that to be the case?

[Bob]

Feb 11, 2016 19:02:28 GMT paulbee said:

Thanks Bob, I knew it could be used in non TC but from what I've read the flavour is miles better in TC, do you find that to be the case?

I haven't tried my wire yet, but I definitely like my Crowns & Tritons with the ss coils on the mods that have a SS setting, and I do find the flavour better on than on the Tritons that I have Nickel coils in.