phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Feb 17, 2016 8:13:50 GMT
www.fasttech.com/products/1436802I didnt like the drip tip so changed it for one of Also from fastech.. Its got a shallow or hardly any juice well so suits a very long fluffy wicking.. i fitted with 2 x 1 ohm coils and wicked with a lot of cotton folding it under the coil.. the 2 x air holes allow for a DTL vape and it gives a nice flavour.. twisting the top cap will close off air in for a MTL vape too and for $3.01 or £1.95 its well worth the money.. Just drip a bit more often to keep the wick saturated and dont over drip as the unabsorbed juice capacity is minimal. when it comes to mods and tank attys i prefer an understated look, but when it comes to dripers im a sucker for bling and gold plating if your looking for a budget dripper with an accessible deck I will admit its been sat here a few months, i was doubtful of it due to its low cost, I wicked it up last night and tried the LiQuid #2 high vg juice in it. and was pleasantly surprised buy both these budget vape options..
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Feb 17, 2016 13:29:55 GMT
after a bit more vaping with this, i have discovered that pulling 1 oring from the cap reduces its tight seal and lets the cap get pulled to rejuice.. and also lets you sit the cap a bit high so the air in holes are wide open, the cap when full down blocks the air in and while it has a number of holes of different size to restrict the air in for a mtl vape lining them up takes a bit of attention..
|
|