Please note, any banner ads that you see at the top & bottom of the forum are placed there, not by us, but by our host Proboards. Therefore neither the items advertised, or the vendors, are endorsed by this forum.
To see AAE-C's Statement regarding MHRA appointment as regulator Click here
Or you can get the universal 7/0.2 equipment hook up wire from almost anywhere but they may not fit some ego type battery tubes because of the thickness..These have the proper current rating but you can get away with smaller cables because current is not continuous till you have a short..
Post by Batdragon (AKA Batty) on May 4, 2012 1:49:18 GMT
I have some (what I seem to remember is) 7 x .13 which has an outer Dia. of 1mm left over from an old project. Not huge ammounts but enough to pass some out. If you are wanting some pm me with your address and I will put it in the post to you. It is only 2 colours I have, one is in a lovely metalic Red and the other in a metalic Green. Say how much you want and I will do my best, though like I said I do not have huge ammounts so it will be on a first come first served bases. (oh and dont be greedy as i would like to share the joy about lol)
I have a problem This is my test before i make the pipe As i said before this is an old board i am trying to reuse.
The pink and green wire are negative/ground on the attie The white wire is going to the centre pin on the attie and the black is going to the battery postive. As far as i tell the wiring is ok,no shorts but i have permanent voltage going to the attie
When i connect the wires the board flashes twice stays on for 5 secs then flashes 5 times Is the board duff?