Moggy
Super Member
Joined:January 2013
Posts: 1,545
Location:
Likes: 720
Recent Posts
Last Online Jan 5, 2017 3:25:46 GMT
|
Post by Moggy on Mar 7, 2013 11:14:20 GMT
Think I need a couple of gallons of water and a run round the garden. Only vaping 12mg juice atm while doing these trials but I may pass out otherwise
|
|
robby
Super Member
International Bargain Master
WISMEC? Check out the Member`s Only thread.
Joined:September 2012
Posts: 13,815
Location:
Likes: 8,652
Recent Posts
Last Online Jun 24, 2013 9:58:00 GMT
|
Post by robby on Mar 7, 2013 11:20:20 GMT
Dont ya just love electronics lol
|
|
Moggy
Super Member
Joined:January 2013
Posts: 1,545
Location:
Likes: 720
Recent Posts
Last Online Jan 5, 2017 3:25:46 GMT
|
Post by Moggy on Mar 7, 2013 11:37:53 GMT
I was doing some work at Centronics in Addiscombe(Croydon) the other day, dropped a few hints about needing some non-res wire and kanthal etc, didnt work Bet they had loads in a skip around the back heh.
|
|
Deleted
Joined:January 1970
Posts: 0
Location:
Recent Posts
Last Online Nov 29, 2024 11:07:51 GMT
|
Post by Deleted on Mar 7, 2013 11:38:33 GMT
I recoiled my Aga-T2+ last night with .25 which came out at 1.1ohms but that was too low for the Vamo, added another coil and got 1.3ohms which was mental lol. I recoiled it again with .20 and that came out at 2.0ohms, bit higher than I normally use with the Aga but all is well. Using 6.5 watts at the moment but have been going up to 12 watts but averaging 8 watts.
One of my Novas is 1.5ohms and the other is 1.3ohms.
|
|
Moggy
Super Member
Joined:January 2013
Posts: 1,545
Location:
Likes: 720
Recent Posts
Last Online Jan 5, 2017 3:25:46 GMT
|
Post by Moggy on Mar 7, 2013 11:43:30 GMT
I recoiled my Aga-T2+ last night with .25 which came out at 1.1ohms but that was too low for the Vamo, added another coil and got 1.3ohms which was mental lol. I recoiled it again with .20 and that came out at 2.0ohms, bit higher than I normally use with the Aga but all is well. Using 6.5 watts at the moment but have been going up to 12 watts but averaging 8 watts. One of my Novas is 1.5ohms and the other is 1.3ohms. Recoiled my Nova's with .20 and 4 turns all hit 2ohms, with 2mm wick. Havent managed to get any lower than that with .20 .
|
|
robby
Super Member
International Bargain Master
WISMEC? Check out the Member`s Only thread.
Joined:September 2012
Posts: 13,815
Location:
Likes: 8,652
Recent Posts
Last Online Jun 24, 2013 9:58:00 GMT
|
Post by robby on Mar 7, 2013 12:40:21 GMT
I recoiled my Aga-T2+ last night with .25 which came out at 1.1ohms but that was too low for the Vamo, added another coil and got 1.3ohms which was mental lol. I recoiled it again with .20 and that came out at 2.0ohms, bit higher than I normally use with the Aga but all is well. Using 6.5 watts at the moment but have been going up to 12 watts but averaging 8 watts. One of my Novas is 1.5ohms and the other is 1.3ohms. Recoiled my Nova's with .20 and 4 turns all hit 2ohms, with 2mm wick. Havent managed to get any lower than that with .20 . Did you think about adding a turn or two and double coiling the Nova, wicked vaper with two coils in it, should end up at about 1.3 or 1.4
|
|
Deleted
Joined:January 1970
Posts: 0
Location:
Recent Posts
Last Online Nov 29, 2024 11:07:51 GMT
|
Post by Deleted on Mar 7, 2013 12:44:17 GMT
Recoiled my Nova's with .20 and 4 turns all hit 2ohms, with 2mm wick. Havent managed to get any lower than that with .20 . Did you think about adding a turn or two and double coiling the Nova, wicked vaper with two coils in it, should end up at about 1.3 or 1.4 How the hell do you fit 2 coils in a nova!?
|
|
robby
Super Member
International Bargain Master
WISMEC? Check out the Member`s Only thread.
Joined:September 2012
Posts: 13,815
Location:
Likes: 8,652
Recent Posts
Last Online Jun 24, 2013 9:58:00 GMT
|
Post by robby on Mar 7, 2013 12:48:04 GMT
Did you think about adding a turn or two and double coiling the Nova, wicked vaper with two coils in it, should end up at about 1.3 or 1.4 How the hell do you fit 2 coils in a nova!? Have one sitting just above the other and then bend the leads down and twist the wires together so one is actually directly above the other in the "slot" but not touching each other, kinda piggy back style. Then feed the twisted wires as usual as if they were just one wire. It is advisable to cut a slither of the silicone off the top cap to prevent strangling the wicks as you would then have two in the slot.
|
|
robby
Super Member
International Bargain Master
WISMEC? Check out the Member`s Only thread.
Joined:September 2012
Posts: 13,815
Location:
Likes: 8,652
Recent Posts
Last Online Jun 24, 2013 9:58:00 GMT
|
Post by robby on Mar 7, 2013 12:50:59 GMT
Kinda like that That will give you 1.4 ohms in total as they are in parallel. So you also then have 4 times as much metal surface area than you would with a single 1.4 ohm coil, so loads of vaper, loads of wicking ability and you will find that the coils last longer because you have more metal doing the work and spreading the load
|
|
Deleted
Joined:January 1970
Posts: 0
Location:
Recent Posts
Last Online Nov 29, 2024 11:07:51 GMT
|
Post by Deleted on Mar 7, 2013 13:40:09 GMT
Mono it does sound like a connection issue
Try raising the centre pin on the vamo.... in the connector bit...might help
Stop that flashing vamo!!!!
|
|
chrisjw
Super Member
Master Ear Licker
Joined:May 2012
Posts: 8,378
Location:
Likes: 5,594
Recent Posts
Last Online Jan 25, 2016 18:41:24 GMT
|
Post by chrisjw on Mar 7, 2013 13:46:07 GMT
Never used the VV bit...........always use VW at around 8.5-9 watts.
|
|
Phoenix .
Super Member
Joined:March 2012
Posts: 2,720
Location:
Likes: 910
Recent Posts
Last Online Jul 25, 2015 9:03:43 GMT
|
Post by Phoenix . on Mar 7, 2013 14:38:45 GMT
Mine is the same set at 7.0w but keep getting Lo for the V, have just change the juice though that shouldn't make a difference should it? I hope to god it's not the centre pin, I have had enough of that palava with the twists.
|
|
Phoenix .
Super Member
Joined:March 2012
Posts: 2,720
Location:
Likes: 910
Recent Posts
Last Online Jul 25, 2015 9:03:43 GMT
|
Post by Phoenix . on Mar 7, 2013 14:52:46 GMT
I have switched back to the Twist and my nova, but Oh dear it is not half as good as the Vamo, and I thought the twist was the business!
|
|
robby
Super Member
International Bargain Master
WISMEC? Check out the Member`s Only thread.
Joined:September 2012
Posts: 13,815
Location:
Likes: 8,652
Recent Posts
Last Online Jun 24, 2013 9:58:00 GMT
|
Post by robby on Mar 7, 2013 15:37:27 GMT
Mine is the same set at 7.0w but keep getting Lo for the V, have just change the juice though that shouldn't make a difference should it? I hope to god it's not the centre pin, I have had enough of that palava with the twists. What resistance reading are you getting normaly on it?
|
|
Phoenix .
Super Member
Joined:March 2012
Posts: 2,720
Location:
Likes: 910
Recent Posts
Last Online Jul 25, 2015 9:03:43 GMT
|
Post by Phoenix . on Mar 7, 2013 15:44:35 GMT
Robby, I have only had it a day , so I don't really know a lot about setting it, but it was fine vaping on 7.ow but now it is saying lov and I don't what I have done to change it,only changed the juice in my nova? I have put it away now I am so disappointed and frustrated. This Twist I am using is like going back to SDK.
|
|