Fogger V3

[fisher]

 Ok, I am trying to decide whether to bin this or try trading, I am now at my wits end on stopping the liquid leaking from the airholes. I think I have viewed all videos out there, filling it with everything shut but as soon as I try to use it ............. Think If I bin it at least I will stop wasting good juice  lol

[bkkkpewsey]

I have come to the conclusion that there must be a big variation of build quality with these atties.
If you get a good un np
My fogger v3 was my first RBA and I bought it with much trepidation.
However every build I put in it has worked flawlessly - no leaks, no gurgles & no dry hits.
Have you tried the Poo build that Todd did in his review? - that was my first and worked fine.
I am now on micro coil & cotton and again np.
Sorry if that wasn't much help

[fisher]

the fogger is my joint first alongside a steam turbine genesis. Fortunately I have got the genesis running quite nicely with a dual microcoil and cotton setup, will have another look for todds reviews.

Might no get it done till tomorrow as I am working tonight

[ionian]

Feb 23, 2014 18:26:32 GMT fisher said:

the fogger is my joint first alongside a steam turbine genesis. Fortunately I have got the genesis running quite nicely with a dual microcoil and cotton setup, will have another look for todds reviews.

Might no get it done till tomorrow as I am working tonight

How are you setting it up?

Have you added a small o-ring to the positive pin at the bottom?

i use the same method as in Todd's video review (below), with the chimney o-ring removed and a microcoil. I find less is more when it comes to adding cotton. 

However, if it's running through the air hole it sounds as though your atty isn't airtight. Try replacing the o-ring that seals the glass tank to the deck, you should have a spare in the bag that came with the atty. 

todds review and set-up:

[fisher]

I have put the small oring in as per todds video. I'll try a different one in the base and have another attempt, if it fails again will probably try and trade for a genesis. Unlikely to be faulty, more like I am!

[fisher]

Ok , I have tried again as per Todds video, and it still leaks. Is this me or is it faulty, I don't know.

I dare not even offer to trade or sell it in case it is faulty, But I don't have the knowledge or experience to make a decision on this.

I will put this down to experience and stick to something less complicated like the genesis style.

Anyone got some recommendations , got the steam turbine clone already...something better out there? (Stick to clones, not prepare to spend over £100+ on originals lol)

[DiscoDes]

fisher have you tried a Squape Clone? It's the only RBA I've ever had much success with.

[fisher]

No, only tried the two I have already mentioned, will have a look at it in some reviews and videos