Flaming kayfun screw

[Mrsmac]

Hi all, the kayfun is heading for that dent in the wall again as over the last few days I've been getting on and off burnt hits. Turns out the airhole screw in the underside keeps undoing itself thus it's not wicking well. It is a Hcigar clone and I didn't get a spare airflow screw in the pack  any idea where I can get a replacement screw? None of my other spare screws from the other 'funs fit it!

[VapingBad]

Not got one with the air screw there, but a bit of PTFE plumbers tape should stop it working loose.

[Greg]

I'll chech when I get home, if I've got a spare it's yours.

[fiddles]

as VapingBad said a bit of plumbers tape should work

[Mrsmac]

Thanks guys and thank you Greg, mi thinks I will have to order some tape from ebay!

[VapingBad]

It's pennies from most hardware shops, Wicks, Screwfix, Toolstation (21p), B&Q and of course plumbers merchants

[Mrsmac]

Thanks VapingBad will pick some up didn't know it was so cheap! Silly question do I wrap the threads?

[VapingBad]

Oct 2, 2014 14:15:08 GMT Mrsmac said:

Thanks VapingBad will pick some up didn't know it was so cheap! Silly question do I wrap the threads?

Yes, but it will be fiddly you need to hold one end while you get the tape once round then it should hold while you put a second layer on, it doesn't have to be neat and you could trim with a sharp knife of scissors as it will conform when you screw it in.

[VapingBad]

[Mrsmac]

Thank you VapingBad that definitely helps

[Super-Shiny]

Kayfuns are not much fun are they

[Greg]

I have a spare I can send you Mrsmac but it's from a genuine KFL+ so not sure if it will fit, it's quite tiny compared the to the air adjuster on my Kayfun / Russian clones.

Let me know if want it and I'll pop it in the post tomorrow.