My latest pocket mod

[bradkb]

Hey all,

Wife wanted a better mod, and I wanted one that was easier to pocket, and I had a couple of friends ask me to make them some as well, so I got a load of 3XAA boxes, some OKRs and a load of bits.

The biggest challenge was the switch, I wanted a tiny switch, comfy to press, no effort, but no missing, and I found a lovely tactile switch, it sticks out probably 3 mm, and using the control pin on the OKR, works fab.

2 X 14500 900mah batteries last me about a day and a half, which as a heavy vapor is quite good.

The atty connector is a 510 shorty with nut, and have sealed the top in hot glue, there is an LED in there, and a hole through to the top, so when its on there is a nice blue glow, not too bright to blind ya.

The voltage is adjustable from 3.3v to 6v and there is absolutely minimal voltage drop under load.

[kingofswords]

that looks top notch mate, well done.

what compnent do you use to change the voltage?

[bradkb]

Use the Murata OKR-T/6-W12-C, together with a 200 ohm pot and a 220 ohm resistor, allows the voltage to be adjusted from 3.3v all the way to 6v. Very nice to use, and very easy to stealth vape with.

[cigeliquid]

Very nice mod i often wish my janty stick would take two batteries
If only i had the patience to make a mod

[dave]

Very nice mod bradkb. Unusual to see continuously variable voltage in one of these boxes and that is a tiny switch!