Atty stand?

[glen]

Sept 17, 2015 18:36:01 GMT pipeman01 said:

Top man, thanks glen. Much appreciated

No problem mate, as I said give me nudge, as I'm going on holiday next week and hope to have alcohol induced amnesia lol

[alexthebear]

glen are you using a pilar drill for these? I've seen a few pics of your work now and they all look great. I've got some Iroko and Idigbo that would polish up lovely for something like this, just need to find the time to make it happen

[glen]

Sept 17, 2015 18:55:58 GMT alexthebear said:

glen are you using a pilar drill for these? I've seen a few pics of your work now and they all look great. I've got some Iroko and Idigbo that would polish up lovely for something like this, just need to find the time to make it happen

I know I should do, but no, im just setting it up in a jig and doing with a normal drill, comes out okay if you take it steady lol

[alexthebear]

Good to know Cheers, will route and sand these bits up to a half decent finish and wang them in the vice

I am more 'chippy' than joiner though so this could go either way

[minime]

Wish I could post pictures on here but for some reason I cannot do it, Iv been making atty /mod holders for sale on another forum.

[chrisjw]

Sept 17, 2015 18:09:21 GMT glen said:

Sept 17, 2015 17:58:14 GMT goneforagasper said:

What size drill bit did you use on that glen. Top work by the way

I ground down a 25mm spade bit to 22.5mm, but a normal 22mm bit wiggled about a bit would probably do the same job
22mm is fine for subtank minis and kayfuns, but you need that little extra for lemos etc

I use a 24mm for the slightly larger atties.................




"Life...........is just a bowl of tricks!!!!!!"

[Deleted]