Best dual coils for 0.5ohm build

[decoy]

the plume should have 3 rectangular holes in the top cap(if its same as mine)and you can pull off that part and turn it round so you only get one hole in the side working for single coil setups

[phatfil]

The fishbone with its bottom entry air in would be a tricky one to use with a single coil and enjoy it fully, some crafty finger blocking may work, but its not an ideal one for single coils granted..

check your plume vail though,if similar to my FT clone the top cap should spin closing off one or both the upper air slots, the 2 x sets of 3 holes lower down on the body piece can be raised up over the well lip or pushed down and twisted round to open or close the 2 x air holes in the juice well wall providing you with an option for a very tight draw to quite a wide open vape.

the bottom well holes to line up with the 3x cap holes are in line with the coil terminals, not clearly visible in the pic.. these when used exclusivly provide a very tight draw indeed,

Though mine is a clone so may not be a 1:1 copy and if so i am shooting wide.. OOps..


www.fasttech.com/products/0/10009122/2037102-plume-veil-styled-rda-rebuildable-dripping

If yours is different, may i suggest you consider a punt on the above its a very versatile rda and one of my favs and for £4.30 shouldnt bust the vape budget.. you will need to appriciate blingy attys tho

[vapevictim]

Feb 29, 2016 16:50:36 GMT phatfil said:

The fishbone with its bottom entry air in would be a tricky one to use with a single coil and enjoy it fully, some crafty finger blocking may work, but its not an ideal one for single coils granted..

check your plume vail though,if similar to my FT clone the top cap should spin closing off one or both the upper air slots, the 2 x sets of 3 holes lower down on the body piece can be raised up over the well lip or pushed down and twisted round to open or close the 2 x air holes in the juice well wall providing you with an option for a very tight draw to quite a wide open vape.

the bottom well holes to line up with the 3x cap holes are in line with the coil terminals, not clearly visible in the pic.. these when used exclusivly provide a very tight draw indeed,

Though mine is a clone so may not be a 1:1 copy and if so i am shooting wide.. OOps..


www.fasttech.com/products/0/10009122/2037102-plume-veil-styled-rda-rebuildable-dripping

If yours is different, may i suggest you consider a punt on the above its a very versatile rda and one of my favs and for £4.30 shouldnt bust the vape budget.. you will need to appriciate blingy attys tho

I will def give that a go looks far better than the one i got from ebay for a tenner ty