The Hadely BF RDA

[tsoko]

Looks like I need to build lower ohms coils

[thebishman]

Feb 26, 2017 19:38:26 GMT tsoko said:

Feb 26, 2017 19:37:56 GMT tsoko said:

Just over 1 ohm

I am still experimenting with it

Yeah im on my 2nd build. Made a big difference too

[thebishman]

Feb 26, 2017 19:42:40 GMT tsoko said:

Looks like I need to build lower ohms coils

I only built it low because of wanting higher wattage from the squueze

[thebishman]

[Deleted]

Feb 26, 2017 19:48:19 GMT thebishman said:

I must say you and tsoko do build very neat coils 

[thebishman]

Feb 26, 2017 20:09:00 GMT @broadblaster said:

Feb 26, 2017 19:48:19 GMT thebishman said:

I must say you and tsoko do build very neat coils 

Why thank you mr b road

[taffevans]

Was it the Sxk one you got then? looks about the best on there...

[taffevans]

Got some3mm 0.75 claptons, one of them would fit nicely in there i reckon....

[thebishman]

Feb 26, 2017 20:15:56 GMT taffevans said:

Was it the Sxk one you got then? looks about the best on there...

Yes mate it was. It was the sxk no toy i got too. I was going to swap the pins over on no toy and coil it up today...but the allen key thats required to do so is not at home...its at work lol

Ill try it when i get bk from my course on thursday

[Deleted]

my eyes and hands will not let me do them so its nice to see you both (and others) get them so nice and precise i take my
off to you all.

[thebishman]

Feb 26, 2017 20:18:41 GMT @broadblaster said:

my eyes and hands will not let me do them so its nice to see you both (and others) get them so nice and precise i take my
off to you all.

You havent tried though russ. A coil stick/rig does the hard work for you! So easy even i can do it

[Deleted]

Cant use mine on my coppervape squonker as the bf pin protrudes too much and leaves a gap
Works great with the non bf pin on my other mods
I need to get another squonker to use it with the bf pin

[taffevans]

Just ordered one of those...cheap enough as well with a Map code...

Thanks for the heads up..

[thebishman]

Feb 26, 2017 20:24:23 GMT @tmfkatubthumper said:

Cant use mine on my coppervape squonker as the bf pin protrudes too much and leaves a gap
Works great with the non bf pin on my other mods
I need to get another squonker to use it with the bf pin

Yeah mine protrudes quite a bit. As does the no toy. Sits flush enough though. Might grind it down slightly to take the pressure off the sprung section of 510 on mod

[car147]

I have the SXK versions, I liked them that much I now have a third on the way from FT.