Wasp nano coiling question

[ghostrider1971]

As I've mentioned before, I am very happy with my Wasp Nano

However, so far I have been making Ni80 coils between 0.45 and 0.6ohms

Even with the air hole closed down, I'm still finding the vape a bit too airy.

My coils are quite small....

Would I be better using a different wire or somehow making the coils wider or vaping at higher ohms and lower wattage?

TIA

(Currently using VT Inbox but have bit the bullet and ordered a couple more Pico Squeezes...)

[domesticextremist]

On my Nano RDTA, I use 1.8Ohm coils for MTL.
The atty is wayy too airy fo rMTL unless you tape over one of the air slots. and close down the remaining one to about 1/4 open.
It certainly helps if you add a 510 drip tip of your choice too.

[phtumshk]

I swore Id never buy another narda type atty again as they are always to airy for me but I never learn.
Do as above or what I do is wedge a shit load of cotton in 1 of the airways on the deck.
Same destination different route.
Its a nice enough restricted lung for me then.