Animodz Doggy Style - Fasttech

[phtumshk]

managed to find some silica and .3 wire.

Been a while but managed to put a pretty shitty lookin coil together lol.

1.4 ohms, not really my cuppa tea but for the purposes of experimentation thought Id go for a standardish MTL build.

Only half filled the tank as if its going to leak it will be when the juice gets low with less vaccuum in the tank.

[buggritt]

No reason it should leak. Even with no wick. And it would only flood if it overwicked like crazy, which is unlikely with silica. Mor likely to dry hit.

[phtumshk]

Jul 13, 2018 19:33:26 GMT buggritt said:

No reason it should leak. Even with no wick. And it would only flood if it overwicked like crazy, which is unlikely with silica. Mor likely to dry hit.

No dry hits so far and no difference vape wise than cotton tbh.

conclusion, may as well stick to cotton as its a load easier to build.

[GunJack]

Thanks guys, will have to give it a try....will report back when done

[GunJack]

Been almost a week wth the doggy now, and for a dedicated Protank/Aerotank user, I'm quite liking it. The stronger nic juice helps with the throat hit (must mix some more up) but I've not tried it with silica as yet. I will do, just for the sake of it, but considering a dvarw to try now as well

[phtumshk]

Jul 18, 2018 7:52:20 GMT GunJack said:

Been almost a week wth the doggy now, and for a dedicated Protank/Aerotank user, I'm quite liking it. The stronger nic juice helps with the throat hit (must mix some more up) but I've not tried it with silica as yet. I will do, just for the sake of it, but considering a dvarw to try now as well

Personally Id skip the silica and try lifting the coil up, I did it with some cotton and the throat hit was quite substantial on my 80vg/20pg 2-3mg juice.

The dvarw is an excellent RTA, probablly the best vape experience Ive ever had from an RTA.

[buggritt]

It's a draw for me. Dvarw is a bit easier to fill.

[djs]

Jun 18, 2018 20:46:01 GMT beedee said:

I have a Doggy styled tank and it’s not bad, but I was not wowed by it so have not used it much.

Me too. I find it underwhelming in all honesty. I must revisit it ASAP.

[djs]

Yes... I've found it. I REALLY want to like it - such a cutie tank.

Can I even remember how to make a 1.0ohm coil? (My wires are all intended for 0.3-0.5)...

[GunJack]

Jul 18, 2018 21:11:02 GMT djs said:

Yes... I've found it. I REALLY want to like it - such a cutie tank.

Can I even remember how to make a 1.0ohm coil? (My wires are all intended for 0.3-0.5)...

i found out how to....take a ft pre made 1.8 ohm and pull it tight from 2.5 mm inside diameter to 2 mm and then unwind a couple if wraps

think i will leave the next one at 1.8