Recent Posts

You da man robby


It is not quite as straight forward as the vid shows, as I had problems finding the files that I had downloaded.....but that was just being un-techi me.

Got there in the end, it seems that as you said, they have added Ti, and the menu for the wire change is a little better.

Not sure if there are any other differences but still a great little mod for the price. All working fine on TC although I need it up at 480f compared to my normal 420f.

Perhaps ron will send them to you after he has finished with them, Perps........hope he ultra-sonic`s them first.

Thanks Greg,
It would not do any harm to drill the holes larger, as you say, the cotton wool is nicely but not too tightly packed,but......I have had no problems with the existing size holes keeping up with the wicking even above 40watts.

I use it for .34mm Kanthal as well @purple1234.
I was using Ni200 for TC, so it should not be fired as it causes the wire to become very soft and unstable.

As this is wound around a threaded M4 bolt, the coil ends up being a spaced coil as opposed to a compressed micro coil.
For a spaced coil, the wires do not touch each other, therefore you do not need to check for shorts/even glow

For Kanthal, I pre-burn before winding around the M4 bolt.

The final ohms reading should have said .16ohms and not 1.6ohms as stated,

Koopor Mod is a great little thing.
I have no problems with the TC and everything works a treat for a bargain price.

Hail