Quick how to on pre coiled wick

Take a Piece of coiled wick, 1and a 1/2-2 inches long

Unwind the wire till you have 6-7 turns left

Snip the wires off, leaving you about an inch to play with and place the ends under the screw posts.

leave a small gap between the wick and the post, say 1 millimeter,and tighten the screws. Be careful to have a correct size screwdriver, the screws will be pretty soft. Then snip off any excess wire

Put a little juice onto the wick where the coil is and check your ohms

Notice your cone/cover will have a hole

Line up the cone against the base, putting the hole over the coil and gently put your wick inside it and push on (The screw covers are normally in the right place when fitted)

Drip a few drops in the hole and put your drip tip on, i only took this off as it has a small hole


There you go.