evod mt3 on an mvp

[cl0wn]

So I bought some cheap evods off eBay (yes I know, lesson learned) I've filled one and it doesn't work. Haven't filled the 4 others but theyre showing up "non" when I check for ohms so I'm assuming they won't work either. Good job they work on swmbo's ego t.

[ionian]

It's possible the pin at the bottom is too high for your MVP. You can pull it down with a pair of pliers - just move it a little bit, a couple of mm should be fine!

[djs]

Most of my Evods won't work on most of my devices. (One of the reasons I don't use them very often).

It drives me insane. I just use an eGo/510 adapter. Solves that problem in one small gadget for mankind.

[cl0wn]

Nov 13, 2013 21:40:38 GMT ionian said:

It's possible the pin at the bottom is too high for your MVP. You can pull it down with a pair of pliers - just move it a little bit, a couple of mm should be fine!

Oooosh! Get that man a beer! Works a beaut! Wont cause it to leak will it?

[ionian]

Nov 13, 2013 21:45:49 GMT cl0wn said:

Nov 13, 2013 21:40:38 GMT ionian said:

It's possible the pin at the bottom is too high for your MVP. You can pull it down with a pair of pliers - just move it a little bit, a couple of mm should be fine!

Oooosh! Get that man a beer! Works a beaut! Wont cause it to leak will it?

No, as long as you've not pulled it down a lot you'll be fine. Glad it worked!

I'll hold you to that beer one day, I have a vodka lime juice that's a beaut with a lager. I'm yet to find a good real ale vape, has anyone found a Quaver crisp flavour?

[cl0wn]

I'm having a beer now, and have four empty tanks, will let you know if I find anything complimentary!

[mart166]

I sometimes get this problem on same setup after rewicking, just undo head and do back up again, nine times out of ten it works fine.

MP