taifun gt fasttech clone help problem

[itsmeiank]

Ok so iv had the taifun gt clone for a while now used it very little as i have quite a range of attys.

The problem i am having is the little peice that slides up and down around the coild with the screw top slides too free and has too much play on it sometimes after a while or if i shake the atty it falls off inside the tank. The o ring is still present and i jave tried washing the tank and air drying it so theres no juice lubricating the little piece.

Im wondering if i put a thicker o ring on the part where the coil sits the bit it sits on if it will help.

Any advice thanks ian

[Deleted]

Try it. I've got one and its ok so not much help. Can imagine its very annoying

[wight]

Take the oring off and put something under it i have used cling film or thin wire

[smeghead]

I put five wraps of cotton under my ring..oh er
Good seal now

[hijack]

I had the same problem. I switched the oring for one of the spares and it was better.
Try the couple of wraps of cotton in the grove before putting the oring back on. I do that for drip tips that don't sit tight and I works a treat.

[dagl]

Twisted PTFE or dental floss if you have any? otherwise any of the above ^^^