Kayfun lite- Help Needed Please

[buliwyf]

I've just built my first Kayfun Lite micro coil. Reading is 1.8 ohms on the vamo, But my DNA 30 says check atomiser ? I just dont know what to do.

[lisburnvapes]

Sounds like it's not connecting with the 510 on your DNA , I've some that don't work on certain devices, try either lowering the centre pin on the kfl or lifting the pin on the DNA , hope this helps

[Tom]

Some kayfun clones don't have a very low centre pin. If you check the kfl bits in my signature. The fill screw o rings make a great little extension. Unscrew the centre pin. Pop an oring on the post. When you screw it back on, the post will be low enough to fire on all your devices.

[buliwyf]

Thank you, How do i do that ? sorry for the stupid question

[Tom]

You can also find a rubber oring like that in an old disposable lighter. Or cut he base of a kanger gromit to use.

[Tom]

Il make a mini guide now bud.

[buliwyf]

Thanks tom, will check out your link,

[buliwyf]

That would be great tom!!!

Its this kayfun lite i have

www.fasttech.com/p/1700500

[Tom]

Yeh the centre post can be high on those.

Stand by.

Sadly you cannot do this and keep your build intact.

[chykensa]

Be careful when unscrewing the centre pin, as it holds the larger of the two blocks on the coil deck in place, and when you unscrew this pin that block in effect floats, not being connected to anything.
When you have made your modification (I use a small piece of plumbers PFTE tape to lower that pin slightly), make sure you hold that block carefully in place as you screw in the pin, also ensuring that the block doesn't touch the other smaller block - this will cause a short and all sorts of elecktrickery problems! You should be able to see daylight between the two blocks.
I have found this out the hard way, so just wanted to warn others - Tom, you may wish to include this info in your guide?

[buliwyf]

Its too confusing for me, should i just send it back guys ? I'll wait for tom's guide first i suppose

[chykensa]

My rather over-wordy explanation above makes the whole process sound far more complicated than it actually is, buliwyf! This is an easy thing to sort, and should be done with no coil build in place. Give it a go with some plumbers tape or a spare O-ring and you'll see just how simple is is in reality!
Of course, we should wait for Tom's guide

[Tom]

just waiting for pics to upload...

should be 5 mins

[buliwyf]

Thanks Chykensa

Tom you've been unbelievably helpful. Thank you for your time and effort

[Tom]

allaboute-cigarettes.proboards.com/thread/48393/lowering-kayfun-centre-pin-guide