Bubbling and Ejuice collecting in Squape R

[westyorkylad]

Hi All

Right I am looking for some help with the Squape R, I have so far managed to fix the flooding issue I was having, I have also fixed the jumping Ohms Issue I then encountered now I just have one problem left that I cant seem to fix and its really starting to bug me and making me consider putting the Squape R back in its box and forgetting about it.

Every time I set it up I am getting a lot of bubbling when its vaping, this results in a lot of Ejuice gathering at the top of the unit in between the outside top of the tank and the bottom of the drip tip, three decent hits on the Suape and I am having to pull the tip off and mop up the Ejuice on the bottom of the tip and the top of the tank, as an unpleasant side effect I am obviously also getting to eat a fair amount of the Ejuice which isn't great.

I am using a 28 AWG Kanthal coil 2mm diameter and 0.95 Ohms, I have wicked it with cotton and I have the cotton just about reaching the bottom of the grooves in the deck, I am using the W deck and vaping at around 10 watts. The coil is positioned halfway out of the top of the deck with the centre of the coil level with the top of the deck.

Hopefully somebody may have encountered this problem and know the solution to fix it, as I am so close to getting this RTA working perfectly!

Thanks in advance people.

[Ripshod]

Try turning the watts up to vape that excess juice off. If that doesn't work then either you haven't fully fixed the flooding or you're you're not using enough wick - try a 2.5 or 3mm coil. Mine is happy with a 3mm coil on the wide deck with the wick roughly half way down the channel, at 14-16 watts.

[westyorkylad]

Mar 20, 2015 18:50:31 GMT Ripshod said:

Try turning the watts up to vape that excess juice off. If that doesn't work then either you haven't fully fixed the flooding or you're you're not using enough wick - try a 2.5 or 3mm coil. Mine is happy with a 3mm coil on the wide deck with the wick roughly half way down the channel, at 14-16 watts.

Cheers ripshod ....... I have tried turning the watts up but its only marginally better an it spoils the flavour ........ill build a bigger coil an use a bit more cotton an see if that fixes it ????

[debra465]

Mar 20, 2015 18:50:31 GMT Ripshod said:

Try turning the watts up to vape that excess juice off. If that doesn't work then either you haven't fully fixed the flooding or you're you're not using enough wick - try a 2.5 or 3mm coil. Mine is happy with a 3mm coil on the wide deck with the wick roughly half way down the channel, at 14-16 watts.

3mm coil for me too, very generous with the cotton, trimmed roughly to the end of the deck.
nearly all the cotton sitting on top of the deck, with just a tiny bit dangling in the channel, no more than halfway down.
Squape heaven 

[Deleted]

I think having the wick down to the bottom of the grooves and a 2mm dia coil are the cause of your problem westyorkylad

Like debra465 I only use 3mm in the W deck. The deck is 3mm wide so it makes sense to fill it. I trim the cotton tight flush with the sides of the deck. Hope that helps.