Aga-T cramp...

[lfcpops]

So I finally got a hotspot-free stainless steel wick and coil in my Aga-t (my first successful stainless steel wick - yay me!), but the airhole was 90 degrees out so it's too harsh. So I order some sandpaper, and finally tonight I get a bit of time to sand down the top to get the airhole to line up. I test it on my Twist and it vapes nicely at 3.6 volts (I assume the resistance is somewhere in the 1.6-1.8 mark - nothing to check it but my measurements reckon it will be). It just looks a bit top heavy...and won't stand up.

No problem. I get out my only mod - a lovely silver bullet. I screw it in and... nothing. The post doesn't make contact. I try an adaptor I have, but again no contact.

Is there anything I can do - is the centre post adjustable in some way? Is there an adapter? Or am I just gonna have to wait and hope it fits on my forthcoming Zmax (fingers crossed!). I'm only wondering cos I'm getting cramp holding my twist upright!!!

Lovely vape though...

[Mev]

you can loosen the lowest nut on the center post a little.

[alanfinal]

Your Aga T wont leak (or is that leek or is that a welsh vegetable) hold it completely upside down and be amazed

Edit added r to you to make your because Iam pis**d