510 sockets

[maccafan]

Nice..I like that charging post..Nice idea..

Chris built me one which was a two level system which is compact but holds a lot..I haven't got as much stuff as you have though..

[lobeydosser]

Macca, that is only what is in use.
The Carp fishing box with all my bits & bobs is under the bench and to the side is the 2 drawer filing cabinet. Top drawer for files. Bottom drawer for PG & VG.
Oh and the freezer has a few (!!!) bottles of nic base.

Personally I blame this all on Skycig.

Oh and perhaps this forum and 6 months of vaping.

[izan]

Okay,
Take old Vivi nova, remove threaded center post from base (Pliers) Drill hole in wood, push and glue VIVI post in hole.
Repeat.
I have one mounted in the "support"hole on my £ 5.00 lidl magnifier/solder station using the set screw to lock it in.
Even have a parts tray/ drip tip tray.

I

[lobeydosser]

Sorry Izan, not with you there.
How would that support all my attys, tanks, buds and Nanos?

[izan]

Granted you would need a few.. however, they are perfect to drop into a 7mm hole and EVERYONE has one or two vivi nova in various states around.. thinking donations would be easier asking for a specific piece.
sorry if I was un-clear.
I

[lobeydosser]

Sorry Izan, I still cannot figure out what you mean.

It is my idea that I will have say an approximately 14" by 4" by 3/8" of aluminium bar with enough 6.25mm holes drilled in it to take 6 Buds, 4 Nanos, 4 Viva Novas, 2 Spheroids and about 6 rebuildables.
All of these holes will then be tapped to allow me to screw the 510 connectors into them, thereby holding them all firmly to the plate and allowing me to easily, but securely, carry them around.
I will also be able to use this bar/plate to secure a rebuildable when I am rewicking it, or I may make up a seperate plate for doing that.

The yellow tray picutered above holds my "daily using" clearos, egos and juice, plus it recharges my batteries.
This new tray is to store my "not in use" attys to save them being damaged by bashing together in a box.

[izan]

I thought you needed 510 sockets/recievers/ threaded connections.
I was suggesting using the recycled center post from VIvi novas/ stardusts.
I had not noticed the ALU bar mentioned in the first post... however, instead of tapping each hole, drill it tapered and insert the aforementioned vivi part.

I can email you a picture if you like, since me words produce not the vision in your head I so desire.
Or you can ignore an old hippy...
Best of luck.
I

[lobeydosser]

Yes please. Email me

Email address removed.