Dream SS

[oxo]

May 31, 2013 17:45:00 GMT chrisjw said:

May 31, 2013 16:59:06 GMT oxo said:

Im going to lift the coil as close as poss to the outlet at the top of the chamber.
Its only about half a cm, the use of non-res will keep the glow at the top where I want it, and not extending down to the post pins.

The coil is already in the chamber Im just going to lift it, Ive only One chamber surrounded by the tank, hope that clarifys it a bit.

yep, gotcha..........look forward to hearing if it helps the vape.............

I did a bit of a rush job and got the ohms out a bit high, I normally vape round 2.4 and should of been aiming a lot lower even so the vape is noticeably warmer.
What ive done is make up a no-res res wire the res bit being about 2.5cm.
Then wrapped the whole lot into a coil around doubled up 2mm wick, the non-res stilts are coiled around the wick to hold it near the pins and stop the wick twisting when I put the chamber back on.
Im not practised in making low res coils but Im sure this will only get better if I go down the resistance as suggested by macca, Ive tried upping the voltage but got a few dry hits. vapour production is better than how I had it set up.
The tinkering continues .

[chrisjw]

Well done mate............It's good to try out different set ups

[Promethian]

I have 2 extended s/s dreams and another on the way.

I rewick them as per the video shown above and they are brilliant. (That
is a figure of 8 wick with 2mm thread and 32 guage kanthal.)
I also fill it from the bottom and plug the drip hole.



I find the Vamo S mod makes the whole package better manageble, and it also doesn't fall over and break!!!


I will soon have 2 more of the above systems in my collection once the parts mods arrive
Then I will be beautifying the whole package with a little golden and black effects.. will post results

[archiecat]

May 31, 2013 15:30:38 GMT kirrielad said:

This is how I set up mine, videos not in English but the setup works flawlessly

Thanks for posting kirrielad, tried this method and it works like a erm well you know

[Andy Thatcher]

I have the original and should be getting the extended version this weekend.

Liked the original just at 1ml capacity far too small to take it anywhere other than to the shops. That and while I didn't get dry hits they were inconsistent but have to play some more.

Will be copying the wick idea with XC-116 to see how that goes.

[maccafan]

I ve just now filled this after trying different methods by leaving the cone fully pushed into the top cap and removed the base, filled 3/4 of the way and screwed it back in.

Not a drop anywhere and is vaping very well. The cone is not screwed down all the way and seems to help with the wicking. Go figure!