First attempt at an RBA

[dannyw14]

Recoiled my RSST for the first time yesterday. Oxidised the mesh, rolled it to size, wrapped the coil onto the mesh, tested for hotspots, adjusted, done. Took about 10 minutes in total and it's working well. Well technically it's my second attempt, i had previously tried to build the aga-t with silica, but had problems getting the silica into the holes (didn't have any mesh).

So all in all, quite proud of myself, wasn't that difficult.


On a side not, i've lost the nuts for my aga-t, where can i get more?

[Deleted]

Nothing worse than losing your nuts!

The nut size is M2 if that helps?

[dannyw14]

Cheers i'll go hunting

[kirrielad]

Normally get one or two in the spares that come in the box mate

[dannyw14]

yeah i've got one, just need 2 more

[oldsmokey]

A mate gave me a few (think he got them on Ebay) - PM me your address and I send you half a dozen.

[dannyw14]

Thank you very much.

I should also point out that i drilled out the air hole on the RSST to 1.5ml and it is so much better now. with the stock air hole it just wasn't usable for me