Fixed my hot button on KTS+

[Deleted]

Well, seemingly my KTS+ fell victim to the hot button syndrome, probably because its the "stainless steel" version, the problem was the plating, it was causing resistance and heating the button up when fired, rapidly also if used with sub ohm.

Well i fixed it with my dremel (can be done with sandpaper), you need to sand off the part of the post which makes connection and sand off the bottom of the button post also

So if anyone has this problem consider sanding it off.

BTW, the button does come out of the KTS+ it's reverse threaded into the body.

[markm]

With the higher amps draw of a sub ohm coil you soon find any
Points of resistance in a mec mod.

[Deleted]

Indeed, but the button was exceptionally bad, it almost burnt me! fixed now tho. got a 0.8 in an IGO-W at the moment

[niam]

I had problems with dual coil setups not working properly and figured the issue was due to the unbranded low quality batteries i had, finally got some AW batteries and it made all the difference.

[-V-]

Thanks for this.
I have been using my KTS+ brass and chrome for a while now and love it
So I ordered the all chrome one, and right away I noticed the hot button thing.
I will give what you said a go later today.

[-V-]

Just did what the OP said with sandpaper and it's worked a treat.
No more hot button
Big thanks...

[Deleted]

No problem mate