Rebuildables

[chykensa]

Is there enough space in a Magneto for a Kick too? I'm just finding out about these, and am already tempted by the Magneto, but would like to learn more about a Kick and what it does.
Any help would be appreciated - maybe I should start a new thread so as not to hijack the OP, apologies

[Fallen Angel]

There is enough room for a kick with either 18350 or 18500 batteries (I do not know about other size batteries as I only use 18350 in mine). It turns your mod into a vv/vw as you can change your watts from 5w-10w or 15w with the v.2 as well as providing low voltage cutoff so you cannot completely discharge your battery it also provides a constant regulated power output.

[vapez85]

I want a nice looking mech mod to go with the rebuildable octopus. First time dripper atomizer, i understand that when i rebuild if i want to do a low res like 0.8 ohm coil i would have to use a mechanical mod. I have had a look on fastech website and they have quite a few on there but not to sure what one to go for! Free worldwide shipping :-)

[Perpetua]

You will for sub ohm coils . . . there's loads of choice for mechanical mods on FT, depends whether you'd rather have a bottom or side activation switch Vapez.

I'll start the ball rolling with this one:

www.fasttech.com/products/0/10004713/1376100-kts-mechanical-mod-e-cigarette-battery-compartment

[dnglos]

Sept 15, 2013 20:35:46 GMT vapez85 said:

I want a nice looking mech mod to go with the rebuildable octopus. First time dripper atomizer, i understand that when i rebuild if i want to do a low res like 0.8 ohm coil i would have to use a mechanical mod. I have had a look on fastech website and they have quite a few on there but not to sure what one to go for! Free worldwide shipping :-)

If this is going to be your first rebuildable set up you really ought to start with something that's safe and simple. Putting a sub-ohm coil on a fasttech mech mod doesn't sound at all safe to me.

[vapez85]

Ok a 1.8ohm coil would be ok on mechanical mod?.
I dont see the point in spending 160 on provari when i can get a decent mechanical mod with the switch at the botton.

[vapez85]

I like the nemesis mod on fastech

[dnglos]

Sept 15, 2013 21:13:38 GMT vapez85 said:

Ok a 1.8ohm coil would be ok on mechanical mod?.
I dont see the point in spending 160 on provari when i can get a decent mechanical mod with the switch at the botton.

I think you'd be better off getting something like a Zmax v3. It's got built-in protection and it'll also measure the resistance of your coils.

[vapez85]

I went for the nemesis and the micro d rebuildable. Thanks for the suggestions!