Loving the eVic !

[Deleted]

Nov 4, 2013 16:31:46 GMT Super-Shiny said:

Looking fantastic @freefromsmoking you should get your Diver by Saturday, anything they send out on Monday normally arrives Saturday

I also ordered the 5 pack of spare ceramic cups for the Diver (I will probable need them all   ) and a couple of pyrex Aspires and spare heads to make the postage worth while  .. it has also been dispatched today so lots of vape mail for me  . Waiting for Grey Haze to get the res/non res pre-made coils back in stock .. emailed Billy and he reckons tomorrow  .. so will have plenty of fun (?)  getting the Diver set up over the weekend 

[Super-Shiny]

@freefromsmoking tbh i don't think you will have much problems with the Diver, it's juts a case of finding how to get it work 100%, like all things out there we are trying to find the perfect setup.

If any major problems just gimme a nudge and we can both go on the google trail of finding a solution, two minds is better than one.

[Roscopecotrain]

Nov 4, 2013 16:29:01 GMT @freefromsmoking said:

Oct 29, 2013 14:55:46 GMT Roscopecotrain said:

Make sure we get some piccies when it arrives.

Sent from my Galaxy Note 2

Here you go Roscopecotrain  ....  fitted with a SR boge carto (2.1 ohm) and it is vaping like a steam train at 6.5 watts (3.7 volts). Loads of flavour and vapour  ...  I can't wait until the Diver arrives from Pink Mule ... dispatched today so hopefully I will get it for the weekend and then the fun will begin 

Looks great ffs. You might have swayed me to the scuba tank now. The shiny rings will match up very well with the shiny rings/parts on the nemesis clone.

Sent from my Galaxy Note 2

[Deleted]

Nov 4, 2013 17:18:12 GMT Super-Shiny said:

@freefromsmoking tbh i don't think you will have much problems with the Diver, it's juts a case of finding how to get it work 100%, like all things out there we are trying to find the perfect setup.

If any major problems just gimme a nudge and we can both go on the google trail of finding a solution, two minds is better than one.

Thanks Rom  ... I have watched every Diver and Scuba video that I can find on you tube especially the Atmistique videos and have extracted every tip and pointer that I can. I have typed up this step by step idiots guide and I will be following it step by careful step: 

SCUBA TANK AND DIVER SET UP

Lubricate the O ring on the base with a little e-liquid

Screw the tube and base together and mark on base where the e-liquid feed hole ends up

Make a coil with 2 x 2mm silica wicks and 5 wraps of Res/NonRes wire

Cut one leg of the coil a little shorter than the other and feed the legs through the holes in the ceramic cup

Fold back the negative leg and then cut and push the positive leg into the 510 pin hole of the ceramic cup

Insert the 510 pin fully into the bottom of the base

Insert the ceramic cup into the top of the base ensuring that the wicks are to the sides of the e-liquid feed hole mark .. Hold the 510 pin firmly against the bottom of the base while pushing the ceramic cup firmly into the base

Twist off the excess negative wire

Cut the wicks on both sides level with the top of the base threading

Ease the coil up a little if it is too close to the top of the 510 pin  ...  this is a major cause of leaking

Wet the wicks and coil with e-liquid

Wiggle and push the tube over the ceramic cup until it reaches the threading on the base

Trim / tuck in any excess wick that is showing

Screw home the tube

Lubricate the O rings in the Scuba tank caps with e-liquid

Insert the diver into the Scuba tank through the bottom cap with the e-liquid feed hole of the Diver in line with the fill hole in the Scuba base cap

1st time fill .. half way

Thereafter .. fill to just below the e-liquid feed hole on the Diver

NOTE: To avoid damaging the ceramic cup during disassembly, first try to wiggle the ceramic cup out of the base. If this is not succesful, insert a screwdriver into the 510 pin and turn it from side to side to loosen its grip on the ceramic cup and then try removing the cup again.

[Roscopecotrain]

@freefromsmoking these 2 have just made my mind up on the scuba tank on the nemesis. Gorgeous. Especially as it will be kicked so the nemesis kick ring will be on it.





Sent from my Galaxy Note 2

[Super-Shiny]

@freefromsmoking you do the same as me, my homework on things, after reading 100's of pages i copy and paste into notebook for future reference

[Deleted]

Nov 4, 2013 17:47:12 GMT Super-Shiny said:

@freefromsmoking you do the same as me, my homework on things, after reading 100's of pages i copy and paste into notebook for future reference

One of the best tips I found was the bit about easing the coil up and away from the 510 pin as far as possible. If it is too close, excess juice on the coil can touch the pin and run down it causing leaking.

[Deleted]

Nov 4, 2013 17:27:50 GMT Roscopecotrain said:

Nov 4, 2013 16:29:01 GMT @freefromsmoking said:

Here you go Roscopecotrain  ....  fitted with a SR boge carto (2.1 ohm) and it is vaping like a steam train at 6.5 watts (3.7 volts). Loads of flavour and vapour  ...  I can't wait until the Diver arrives from Pink Mule ... dispatched today so hopefully I will get it for the weekend and then the fun will begin 

Looks great ffs. You might have swayed me to the scuba tank now. The shiny rings will match up very well with the shiny rings/parts on the nemesis clone.

Sent from my Galaxy Note 2

It is a very well finished tank Ros  ... very well machined and good quality O rings. Filling it is a doddle and you get the full 3 ml capacity with the caps being a push fit onto the outside of the tank rather than screwing or pushing into it. There are options to customise the looks by changing the middle ring to a different finish  ... brass and black for example. 

[Roscopecotrain]

Nov 4, 2013 19:11:25 GMT @freefromsmoking said:

Nov 4, 2013 17:27:50 GMT Roscopecotrain said:

Looks great ffs. You might have swayed me to the scuba tank now. The shiny rings will match up very well with the shiny rings/parts on the nemesis clone.

Sent from my Galaxy Note 2

It is a very well finished tank Ros  ... very well machined and good quality O rings. Filling it is a doddle and you get the full 3 ml capacity with the caps being a push fit onto the outside of the tank rather than screwing or pushing into it. There are options to customise the looks by changing the middle ring to a different finish  ... brass and black for example. 

Yeah i did see blue and red ones here www.atmistique.gr/en/craven-series?category_id=75&page=shop.browse&limitstart=0&limit=50 but no pink

Edit: I see you can get sides for it as well so it looks all stainless steel. I like pink-mule.com/SCUBA-TANK-SIDE-ATMISTIQUE

Sent from my Galaxy Note 2

[Deleted]

Nov 4, 2013 19:43:23 GMT Roscopecotrain said:

Nov 4, 2013 19:11:25 GMT @freefromsmoking said:

It is a very well finished tank Ros  ... very well machined and good quality O rings. Filling it is a doddle and you get the full 3 ml capacity with the caps being a push fit onto the outside of the tank rather than screwing or pushing into it. There are options to customise the looks by changing the middle ring to a different finish  ... brass and black for example. 

Yeah i did see blue and red ones here www.atmistique.gr/en/craven-series?category_id=75&page=shop.browse&limitstart=0&limit=50 but no pink

Edit: I see you can get sides for it as well so it looks all stainless steel. I like pink-mule.com/SCUBA-TANK-SIDE-ATMISTIQUE

Sent from my Galaxy Note 2

I actually prefer it the way it is ... ss, clear, ss, clear and ss  ... you could always put some pink juice in it to customise to your liking! 

[Village idiot formerly tjlumle]

How much was the scuba you lot are gonna get me in trouble hahah

[Village idiot formerly tjlumle]

Also 19 or 22mm?

[Deleted]

Village idiot formerly tjlumle .... 22mm and it cost me about £36 including postage

[Village idiot formerly tjlumle]

Doh! Just seen the fotia is back in stock with black o rings but looking at Siam on atmistique but just can't translate the website on my phone. Where did you buy from?

[Deleted]

I got both the Scuba tank and the Diver rba from Pink Mule .... The Diver wont arrive until this weekend so I am using the tank with a Boge carto atm