pro tank 2 - cant get it to work

[clivealive1]

hmmm should the pro tank 2 have a plastic cover over the mini wicks   or not , just thought maybe it could be the reason for issues???????

[DiscoDes]

clivealive1 It should look like this:



Plastic cap on top. It does not matter if the grooved tube is longer.

[clivealive1]

on mine the wicks are showing and not covered

[DiscoDes]

Nov 28, 2013 17:54:30 GMT clivealive1 said:

on mine the wicks are showing and not covered

It should look like the picture above, anything else is not right.

[clivealive1]

thanks lads, will take it apart in a while and check it out.

Itsa that i found a small cap on the floor but its only tiny, not sure its that cap.

[Deleted]

Others above have pointed out the problems that are caused by screwing your device on too tightly. What can also occur and which may well be the cause of your tight draw problem is that the little rubber grommet at the bottom of the atty can become over-compressed and will then block the air holes in the protank.

[clivealive1]

thanks yes i did make sure it isnt screwed to tight now and pulled pin out a little on battery

[clivealive1]

ok opened up and cap did fit, still not what i would expect but will order a 1.8 ohm coil to replace the 2.5 ohm thats on it and see how that goes. running on 1300 mah ego and previous comments suggest 1.8 or 2.0 ohms

thanks guys