Russian and Ithaka rebuildable atomizer from VB

[melitahams]

I just got these atomizers today together with the Ithaka Rebuildable Polished (Clone) and the Taifun GT Rebuildable from Vapor Break. One thing that pissed me a bit is that the there was no instructions or any paper work unlike other itomisers that I bought before, but anyway I managed to do them . I can say that for the price I payed I'm very happy with them mostly with the Taifun GT as it really looks great.I got a small problem regarding the Russian clone as the center pin which makes contact with the mod is a bit down and when attached to the mods both the Evic and the Smok it stays about 1mm gab to the top, I attached a picture to see what I mean .Is there something wrong or something I can do to fix this? All I know that it is a screw as when I dismantled it i took  it off and that there is a plastic inside as I was thinking to get the plastic out and trim it. Other thing I don't like is the dip tip as it have a narrow hole is it OK to make it a bit bigger?




Now about the Ithaka , I thought  it would produce more vapor , don't know as I used the coils it comes with but will try to coil new ones this coming week as well 

[Super-Shiny]

Think you can sand down the insulator under the screw a bit but careful not to do too much.

[Super-Shiny]

This guide is for the Kayfun: Clicky

[melitahams]

Dec 23, 2013 18:48:10 GMT Super-Shiny said:

This guide is for the Kayfun: Clicky

I will give it a look Thanks Super-Shiny

[melitahams]

Guess I can make it I try it now and let you know

[chrisjw]

Don't try & screw it in too much, as it'll snap the centre post......that's what happened to my 3.1 clone

[melitahams]

Holy shi........... it doesn't come out. I had to use a drill bit a bit smaller than the SS hole not to damage the base and slowly by hand twisted it around little by little till I get the size out , then I flashed it out with a flat screwdriver as again twisting it slowly. Now it sits much much better Thanks Super-Shiny

[Super-Shiny]

Good to hear it's all sorted now melitahams

[melitahams]

First Happy Christmas to all

I Have a problem regarding the Kaifun clone as I cant get a good vape from it unlike the Taifun Gt as it's really a beast. Anyone had the same issue before or know what it could be ? I did coil it with 2 wraps of 2mm silica and .2 Kanthal A1 Heat Resistance and got it 1.9 ohm it vapes but I pretended to give more

[fiddles]

Have you adjusted the AirFlow (small allen key into side) ?

[melitahams]

Dec 25, 2013 12:25:58 GMT fiddles said:

Have you adjusted the AirFlow (small allen key into side) ?

Yes I did most of the time while I vape but still no luck. Now II dissamble it again and will make a new coil again and see if it works ok 

[Mev]

i'd sand the screw head myself rather than the insulator, just leave it all in one piece, place some wet and dry on a flat surface and give it a rub over until ok.

[melitahams]

Dec 25, 2013 18:52:28 GMT Mev said:

i'd sand the screw head myself rather than the insulator, just leave it all in one piece, place some wet and dry on a flat surface and give it a rub over until ok.

That I already solved it out and I guess when I put the pin back I tighten it too much as now I did re tighten it and coil it once again and it vapes much better.