Hcigar kayfun 3.1 holes ?

[intheblim]

Hi i have just got a hcigar kayfun 3.1 and im not sure about where the juice fill hole is - pictured below i have 3 holes and i know the far left hole is the adjustable airflow but which one do i use for filling the juice - is it the far right one or the middle one ?

[chrisjw]

it's the one on the right intheblim.................don't use a metal syringe needle though.

[Aldo]

it's the one on the right, if you look into it you can notice there is a small piece of metal inside, this is where you stick you syringe to fill it - BE CAREFUL, DON'T EVER FILL IT WITH A METAL NEEDLE or you will mess up the valve and then there is no turning back, except if you seal it forever with bluetack or a drop of weld and fill from the top.
Make sure you dismantled it all and cleaned it properly removing any leftovers there might be on the holes.



Here is a video that may help !

Just make sure you never stick a metal needle in that hole, trust me, I know from experience it will screw your Kayfun forever... :s

[intheblim]

Apr 30, 2014 16:07:20 GMT Aldo said:

it's the one on the right, if you look into it you can notice there is a small piece of metal inside, this is where you stick you syringe to fill it - BE CAREFUL, DON'T EVER FILL IT WITH A METAL NEEDLE or you will mess up the valve and then there is no turning back, except if you seal it forever with bluetack or a drop of weld and fill from the top.
Make sure you dismantled it all and cleaned it properly removing any leftovers there might be on the holes.



Here is a video that may help !

Just make sure you never stick a metal needle in that hole, trust me, I know from experience it will screw your Kayfun forever... :s
also i have tried one of my other drip tips in the drip tip adapter and it seems to be a bit loose - is there any good tips that fit this ?

[Aldo]

my drip tips have been a snug fit in the adapter so far, but then again, I haven't tried many because:

1: I don't have many drip tips
2: I love the kayfun standard driptip

Cheers

[chrisjw]

You could wind a bit of plumbers tape under the o-ring, for a tighter fit, or fit a bigger o-ring altogether.......