Liquinator O-Rings

[blakey]

Does anybody know a uk supplier that stocks these O-Rings or does anybody know what actual size specification they are? I found a couple that fit and are working for now but I have no idea what size they were.
Ta in advance

[clockworks]

Are they the same size as the o-rings on the RTA and RDA? I've got a few of those!

o-rings are sized by their inside diameter and the cross section diameter, in millimetres. Pull one off and measure it. If it's 12.5 x 1.5, I can help. If not, there's a company called Polymax that stocks every conceiveable size.

[blakey]

Cheers clockworks, they're internal o-rings that seal the shaft of the carto and sit inside a ridge in the end cap and are probably smaller than the sort of sizees that you would use, when this tank is empty I'll take the rings out and measure them and give these polymax people a go.

[clockworks]

I had the same idea to use internal o-rings for sealing cartos. Pretty sure I've got some that'll do the job - 8.5mm internal diameter?
Measure them when you can, and PM me with the size.

[blakey]

Will do thanks steve, 8.5 seems about right for the internal diameter considering a dual coil is about 9mm wide.