Taifun gt tip for weeping ajuster pin

[skanska]

Taifun gt owners tip. I was getting fed up of juice seeping out of the positive centre ajuster on the taifun so I got to work on solving it as I only ever use it on the paps x so thought I don't need to ajust it so I took out the pin and spring and carefully wrapped some ptfe tape around the screw first then put the spring back on the screw then wrapped some more around the top half of the spring so I was left with just enough thread on the screw so I could get a start on the screwing in it looked like a ball of ptfe tape on the top of the screw. I screwed it up and while I was screwing it up the ptfe tape pushes up so while I tighten the screw you get a sharp knife and cut off the excess until you have the screw at the desired adjustment bingo I have a juice tight seal. This is a picture of the finnished seal. Hope you get what I mean I should have done some pictures of the process.

[vicuk]

looks like a good seal will try sometimes you just need to see something but I would have never thought of that well done mate all the best vic

[skanska]

May 13, 2014 18:22:44 GMT vicuk said:

looks like a good seal will try sometimes you just need to see something but I would have never thought of that well done mate all the best vic

hope it works for you as it has for me no mor leaking