jamesrd
Full Member
Joined:May 2014
Posts: 120
Location:
Likes: 34
Recent Posts
Last Online Oct 1, 2019 13:18:04 GMT
|
Post by jamesrd on Jun 27, 2014 18:40:20 GMT
this morning after charging my spinner 2, put it all together and then nothing, no vape at all so I tried it on another one and believe it or not nothing so I changed that one on to my last one and lo and behold bugger all, there was plenty of juice in all of them and they were all charged up so I cleaned and lifted the centre pins and still nothing, I put a new coil in and still nothing, how the hell can this happen to all my vapers all at once? I rang Ash at myecigs and he could not give me an answer, I know this sounds impossible but it's happened and now I have nothing to vape and I'm really getting with drawl symptoms, I know this is a difficult one but would appreciate any kind of response. Jamesrd.
|
|
dalealan
Super Member
Joined:June 2014
Posts: 4,307
Location:
Likes: 3,798
Recent Posts
Last Online Sept 12, 2020 10:07:38 GMT
|
Post by dalealan on Jun 27, 2014 18:44:26 GMT
Coils gone? Bit of a long shot as you've tried another. If the spinners are the same as my ego twist they flash when they detect a short so you can rule that out. Failing all else if you've got a multimeter you could test the spinners giving out voltage with the button pressed. If it is then it points to your tanks. Oh and swear at it that sometimes fixes them
|
|
|
Post by snow on Jun 27, 2014 18:44:41 GMT
Are you sure they are charged? I've found they show green after about 10 mins but they haven't charged at all - you need to switch off and back on and then they will charge.
|
|
charon
Super Member
Joined:August 2013
Posts: 4,106
Location:
Likes: 1,602
Recent Posts
Last Online Jan 27, 2019 9:40:28 GMT
|
Post by charon on Jun 27, 2014 19:53:49 GMT
jamesrd, Just an off chance, but have you compressed the centre pin in your spinner by overtightening onto your charger? Just lift the pin very slightly and give it a go.
|
|
dinamic22
Super Member
Better known as Di but as we have a Di here already i had to use another name
Joined:May 2013
Posts: 1,868
Location:
Likes: 1,070
Recent Posts
Last Online Oct 5, 2023 14:33:08 GMT
|
Post by dinamic22 on Jun 27, 2014 21:31:35 GMT
jamesrd I sometimes have this trouble when i change from 1 Mvp to another & the only thing that gets them firing again is to lower the central pin of the clearo that holds the silicon bung in place hope this helps
|
|
hijack
Super Member
Squeaky Butt Cheeks
Joined:May 2014
Posts: 1,705
Location:
Likes: 1,259
Recent Posts
Last Online Sept 29, 2015 16:59:47 GMT
|
Post by hijack on Jun 27, 2014 21:39:42 GMT
strange it would do it on all 3 spinners if we were talking about the centre pin being pushed down. have you tried a new coil?
You could try doing this to the atty. Pull the pin on the atty out a bit. Its the easy way of finding out if the spinner pin has been pushed down.
|
|
babs
Super Member
Joined:September 2013
Posts: 1,357
Location:
Likes: 657
Recent Posts
Last Online May 28, 2016 18:15:06 GMT
|
Post by babs on Jun 27, 2014 21:43:14 GMT
You could try a different charger if possible as it may be that's faulty which would explain all of your batteries going at once.
|
|
jamesrd
Full Member
Joined:May 2014
Posts: 120
Location:
Likes: 34
Recent Posts
Last Online Oct 1, 2019 13:18:04 GMT
|
Post by jamesrd on Jun 29, 2014 15:48:35 GMT
I eventually figured out what was wrong, I feel a right dope and hate admitting it so don't laugh out too loud, what was wrong was I had both screw heads screwed together so when I was fitting the two parts together it was obviously not connecting to the centre pin, it took me all bloody day to figure that out, am I thick or what, don't answer that I feel bad enough as it is. Thanks for all your replies. JRD.
|
|
dinamic22
Super Member
Better known as Di but as we have a Di here already i had to use another name
Joined:May 2013
Posts: 1,868
Location:
Likes: 1,070
Recent Posts
Last Online Oct 5, 2023 14:33:08 GMT
|
Post by dinamic22 on Jun 29, 2014 16:00:05 GMT
Hijacks pic on reply 5 is what i was talking about.
|
|
Deleted
Joined:January 1970
Posts: 0
Location:
Recent Posts
Last Online Sept 16, 2024 20:07:03 GMT
|
Post by Deleted on Jun 29, 2014 16:01:56 GMT
We have all been there its part of the learning curve.
|
|