1 ohm Dual Coil TOBH

[lee]

Hi everyone, recently got a TOBH of the classies (thanks geordie_vaper). So im going to do a dual coil build and im aiming for 1ohm as i only have red efest batteries (i know i can go down to 0.6/0.7 but im not trying to push the batteries) So the question is am i going to get a decent vape at 1ohm as all the videos i have seen are seriously low ohms like .2 etc!! I'll be using .25 kanthel with cotton? Any advice greatly appreciated!! :-) or have i got the wrong dripper? 

[VapingBad]

I think you are doing the right thing re the batteries. You may find it better to do a single coil and block the air flow on the other side at an ohm.

[Pezz]

You're not going to get the hot vape and huge clouds that a 0.2 build will give you but a good 1 ohm build should give you a great vape on the TOBH.

On mine I have built they coils at a slight angle so you get the maximum airflow.

I'm a big fan of the TOBH for dripping - The dome inside the atomiser is good for flavour and dripping is easy with the two piece top cap.

[lee]

Thanks VapingBad & Pezz, i will deffo try the dual build with coils at an angle gonna aim for 1 ohm, looking forward to the detecting the flavours and getting down with this dripping malarky it all a learning curve

[Deleted]

Jul 18, 2014 10:28:33 GMT lee said:

Hi everyone, recently got a TOBH of the classies (thanks geordie_vaper). So im going to do a dual coil build and im aiming for 1ohm as i only have red efest batteries (i know i can go down to 0.6/0.7 but im not trying to push the batteries) So the question is am i going to get a decent vape at 1ohm as all the videos i have seen are seriously low ohms like .2 etc!! I'll be using .25 kanthel with cotton? Any advice greatly appreciated!! :-) or have i got the wrong dripper? 

2 coils @ .25 kanthal 8 wrap microcoil using 2mm drill bit or similar should give you 1 ohm or there abouts.