Dare I try this?

[jmw2309]

A 1ohm build but looks a bit shabby to me!

Should I try it and see or have another go at it?

[sammy13]

Theres only one way to know if it will work - the question is ---------

feeling lucky punk?

[flavourtank]

Do it.......

[jmw2309]

Custard cream in. And it tastes quite good! I am not into cloud chasing or anything but this is cool! More practice needed though I think.

[decoy]

what are you using it on ?

[prr]

I don't want to be critical but the coil on the right looking down looks a bit iffy, and if that's cotton, lessis more, as it swells when saturated. should pass through the coil with minimal resistance.

[jmw2309]

Using on my VTR.

Thanks prr I am just about to redo it now. It is working ok but looks shit! It is the Japanese cotton stuff in it.

[prr]

The stuff you sent me is good, peel back a small layer of it and CUT a strip about 5mm wide about 25mm long in the direction of the fibres, roll it like a rollie until it is thin enough to pass through your coil with next to no resistance. Took me ages to get this right with the Japanese cotton!

[sonicflowjoe]

Sept 24, 2014 20:51:52 GMT prr said:

The stuff you sent me is good, peel back a small layer of it and CUT a strip about 5mm wide about 25mm long in the direction of the fibres, roll it like a rollie until it is thin enough to pass through your coil with next to no resistance. Took me ages to get this right with the Japanese cotton!

Sounds a good tip that. Might have to give that a try in my. Kayfun. Liking the japanese cotton but still getting the odd wicking problem

[jmw2309]

New build with less cotton looks better and works great! Cannot put a pic on here on phone though.

What ohm does VTR fire down to as it is reading 0.8 and still firing?

[richievanvapes]

Sept 25, 2014 8:05:54 GMT jmw2309 said:

New build with less cotton looks better and works great! Cannot put a pic on here on phone though.

What ohm does VTR fire down to as it is reading 0.8 and still firing?

Don't quote me on this but I believe it goes down to 0.5 ohms. 

I know you can sub ohm on it to a degree and I saw an indoor smokers YT review where he was testing the new 0.8 ohm Kanger coils that are just out and I'm sure he mentioned it going to 0.5 too.