xtc263
Super Member
Joined:February 2013
Posts: 1,021 
Location:
Likes: 218
Recent Posts
Last Online Sept 27, 2019 18:07:41 GMT
|
Post by xtc263 on Oct 26, 2014 19:08:31 GMT
Hi I've been rebuilding kanger micro coils for the last few mths. And they've been quite (chuffed at that) ;)Anyway I use .25 kanthal around a 2 mm drill bit and between 6-8 wraps. Nice and tight. I usually get between 1.5 - 1.7 ohms. I was just wondering any of u who rebuild these type of coils what ur usual set up is ie what wire, drill bit and how many wraps for the best vape. And what ohms u get?
Thanks Laurie
|
|
Super-Shiny
Super Member
SUSPENDED
Joined:January 2013
Posts: 13,131 
Location:
Likes: 10,308
Recent Posts
Last Online Nov 25, 2014 19:31:22 GMT
|
Post by Super-Shiny on Oct 26, 2014 19:10:43 GMT
xtc263 this little chart i made might be useful: 
|
|
xtc263
Super Member
Joined:February 2013
Posts: 1,021
Location:
Likes: 218
Recent Posts
Last Online Sept 27, 2019 18:07:41 GMT
|
Post by xtc263 on Oct 26, 2014 20:51:16 GMT
Thanks super shiny
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Oct 26, 2014 21:25:01 GMT
Great chart !
|
|
Deleted
Joined:January 1970
Posts: 0
Location:
Recent Posts
Last Online Nov 27, 2024 5:14:22 GMT
|
Post by Deleted on Oct 26, 2014 21:28:35 GMT
You're doing just about what I did when started making my own coils xtc263I then used 0.30mm kanthal, 2mm dia 7 to 8 wraps for a 1.2 - 1.4ohm coil. Might be worth a try to see the difference. |
|
