lavatube

[Rodga_H]

just purchased a lavatube and a puff diddy, they both work seperately (with different atomizer and battery) but when together nothing happening, any ideas guys?

[leftfield]

The lavatube's battery post is pretty far down compared to others. It happens with the provari too. You could try a 510 - 510 adapter to get some height back.

Also you can try to gently prise the "thread wings" down from the threaded end of the cartomiser. If you look closely at the bottom of your cartomiser you'll see two "flaps" in the middle circle. If you pull them down it can make the difference of making contact with the battery post or not.

Happens a lot with my CE2's but it's an easy fix

[steve386]

I had this problem on Bel's Lavatube yesterday. One carto just would not work with it. I used a flat headed screwdriver and turned the centre part of the carto battery connector a little and it worked after that.

That was on a Dual Coil carto which had a slot for the screwdriver. If yours does not have that, you can use a paper clip to gently work the centre part down a little. Just don't push the paper clip into the hole too far.

[Deleted]

Feb 10, 2012 17:40:40 GMT steve386 said:

I had this problem on Bel's Lavatube yesterday. One carto just would not work with it. I used a flat headed screwdriver and turned the centre part of the carto battery connector a little and it worked after that.

That was on a Dual Coil carto which had a slot for the screwdriver. If yours does not have that, you can use a paper clip to gently work the centre part down a little. Just don't push the paper clip into the hole too far.

You forgot to say "Simples"

[Rodga_H]

Cheers guys, working like a dream now

[steve386]

Feb 10, 2012 17:43:49 GMT @colliwobbles said:

Feb 10, 2012 17:40:40 GMT steve386 said:

I had this problem on Bel's Lavatube yesterday. One carto just would not work with it. I used a flat headed screwdriver and turned the centre part of the carto battery connector a little and it worked after that.

That was on a Dual Coil carto which had a slot for the screwdriver. If yours does not have that, you can use a paper clip to gently work the centre part down a little. Just don't push the paper clip into the hole too far.

You forgot to say "Simples"

LOL, don't you start

You will be joining the N team next

[Deleted]

No I'm with the L team (right in the middle)