What's your favourite RDA?

[Tom]

I have a few faves for different reasons.

Marquis - love the looks, love the build, love the performance.

Derringer - tiny, easy build, flavour monster, ideal flavour tester or micro atty.

Freakshow mini - again small, cracking flavour, ever so slightly more precious with the build than the derringer but the direct undercoil airflow makes the flavour pop. I have overdressed this a few times though.

Honourable mentions to tugboat v2, veritas and tobh - all been great atties for me.

Ive been done with buying them for a while as quite happy with my lot... although Im very interested in how the velocity clone from ft is recieved www.fasttech.com/products/1/10014538/2482500-velocity-styled-rda-rebuildable-dripping-atomizer

I have learnt patience over the last few years, will wait for a review, hope its good. Had enough of £100+ atties here

[spanky]

Origen v2
easy build, well designed, generous juice well, good performance.

I have had many RDAs in my time, but I find most of them unacceptably leaky. I tend to carry my vaping gear in my pockets and nothing pisses me off more than the discovery of a sticky juice spot on my clothes.

The only RDA that I can trust not to do so is the Origen. My favourite is the Origen v2. I have an Origen v3 which has more airflow options but I'm not so keen on the design - pocket fluff and dirt and general debris gets stuck in those wafer thin slots around the top.

I have a Derringer which is a cute little thing, but I find the juice well crowded and small. It's too leak prone to carry in your pocket with any kind of confidence so I really only use it at home, atop a suitably diminutive 18350 mod. I do occasionally take it out to vape meets, but really I'm just showing off!

I recently inherited a Fogatti Switchblade which is fine and gorgeous thing, but it has, what I consider to be, something of a design flaw; the top cap fits inside the base rather than over it which makes it hard to arrange your wicking material – it tends to get snagged and interfere with the seal. The other thing is the admirable and innovative deck compels me to make fierce three coil builds that fog out a room in a single draw. I know a lot of people like that sort of thing but I'm a discrete vaper – I don't like to draw too much attention to myself on the top deck of the bus or obscuring the screen at my local multiplex...

[Deleted]

I have a few now and my favouties are:

flavour - magma

clouds - baahl

both - mutation x v4

rta's - goblin and the silverplay

[enjay]

Derringer is up there for me now, just got one and am very impressed. Blows big clouds and gives great flavour. I highly recommend it to anyone beginner or advanced.

[teethcv]

Dark horse

[crystal]

Love my Veritas, single horizontal coil 0.4 Kanthal, 1.4ohm running at 18 watts

[Ripshod]

I recently bought a Plume Veil, and while I was happy with it I wasn't happy with how little juice it would hold.

Other side of the coin now, the Plume Veil goes everywhere with me - dual coil 0.3 Ohm goodness that I haven't found anywhere else.

[gm111]

Is this the youde goblin letsavit & @jc72?

[Deleted]

Jun 12, 2015 11:07:18 GMT gm111 said:

Is this the youde goblin letsavit & @jc72?

yeah man but I have the cloned version cost me  £6.37. It's a good clone though compared it to my mates and couldn't tell the difference in performance.

[gm111]

Nice one @jc72, where did you get yours from?

[letsavit]

Jun 12, 2015 11:07:18 GMT gm111 said:

Is this the youde goblin letsavit & @jc72?

Yea, it's almost a under coil air flow dripper without the dripping bit...!

[Deleted]

Jun 12, 2015 12:21:03 GMT gm111 said:

Nice one @jc72, where did you get yours from?

from focalecig

[davetherayon]

Jun 10, 2015 22:11:54 GMT spanky said:

Origen v2
nothing pisses me off more than the discovery of a sticky juice spot on my clothes.

No matter how you shake your peg... oh attys, I see

[Get Off My Cloud]

Been vaping on this Swirlfish clone the last couple of days gotta say it's good little atty, nice deep juice well about 6mm or so, 4 post hole design with decent sized holes, single coil or dual coil side airflow and extra airflow from the top cap.
Only limitation is you're limited to a 510 drip tip, you might be able to find a chuff cap to fit but then you won't be able to adjust the airflow you'll have to have it in dual coil mode fully open.

[conchord]

Jun 10, 2015 21:09:54 GMT Tom said:

I have a few faves for different reasons.

Marquis - love the looks, love the build, love the performance.

Derringer - tiny, easy build, flavour monster, ideal flavour tester or micro atty.

Freakshow mini - again small, cracking flavour, ever so slightly more precious with the build than the derringer but the direct undercoil airflow makes the flavour pop. I have overdressed this a few times though.

Honourable mentions to tugboat v2, veritas and tobh - all been great atties for me.

Ive been done with buying them for a while as quite happy with my lot... although Im very interested in how the velocity clone from ft is recieved www.fasttech.com/products/1/10014538/2482500-velocity-styled-rda-rebuildable-dripping-atomizer

I have learnt patience over the last few years, will wait for a review, hope its good. Had enough of £100+ atties here

What sort of build do you use in the Marquis? I've been struggling to get a decent vape out of mine...

Derringer is my fave at the moment. Really nice, simple and solid little rda