what nextgen clone

[geordie_vaper]

never tried a genny so gave in, chose inax cause it looks the best. and the mega reduced chamber roughly 8mm in diameter

[VapingBad]

Jul 6, 2015 19:06:25 GMT geordie_vaper said:

ordering one tomorrow to give a genny a bash but wich one of the 3 is the best i know VapingBad and blakey have one, wich ones did you go for?

I didn't get one, but I think ervi had tried most of the clones.

[ervi]

I tried the FT version and the Gearbest. I prefer the Gearbest, currently my FT version is gathering dust.
The FT version seems very prone to shorts, never really took it apart to find out.

I have read in some forums the arrival of versions 1.1. The first wave was far from a one to one. You couldn't fit thicker ribbon, the centre post was a lot shorter and the well was narrower. I have not looked into those but it might be worth investigating as they might have fixed a few issues.

It' a great atty if you like genny, forgiving, easy to build and doesn't leak. I still prefer my Origen Genny, cooler vape

[yourgurnard]

Jul 7, 2015 23:29:40 GMT geordie_vaper said:

never tried a genny so gave in, chose inax cause it looks the best. and the mega reduced chamber roughly 8mm in diameter

Not tried mesh in Your Origen?....

[geordie_vaper]

no not yet will try when i give the inax ago

[yourgurnard]

Just thought it'd be a way of seeing if You got on with it before lashing out on another tank......bit late now!!!

[geordie_vaper]

was only a tenner but might try mesh one now

[geordie_vaper]

ok have a problem when i wrap my coild around the mesh they arnt tight enough to it i have the rolled mesh placed through a little screwdrive and still the coils are too loose any tips

[ervi]

Jul 8, 2015 20:59:39 GMT geordie_vaper said:

ok have a problem when i wrap my coild around the mesh they arnt tight enough to it i have the rolled mesh placed through a little screwdrive and still the coils are too loose any tips

Apologies if this isn't new. Have you tried the other way around, putting the mesh wick in a coil already in place? Todd shows this on the video.

It's a quite a method. All you need is a drill bit

You then adjust the mesh to fit the coil.

[geordie_vaper]

[geordie_vaper]

yourgurnard do you put any cotton in the bottom of the origen when your running it with mesh?

[yourgurnard]

No Cotton M8. I'm still on the 2 coils that came with the Ori.3 ....made the mesh wicks fit the coils rather than wrapping wire round the wicks.

[geordie_vaper]

ok make do you take the topcap off when you drip? i normally just drip down the drip tip but finding the wick isnt getting all the juice, maybe i could push the mesh down so its touching the deck of the origen, or would that cause a short?

[letsavit]

Always just used cotton in Origens, think of it as the coil is heating the cotton, not sure about sucking of metal wick and don't know why...some sort phobia...!

[VapingBad]

Jul 9, 2015 22:14:30 GMT yourgurnard said:

No Cotton M8. I'm still on the 2 coils that came with the Ori.3 ....made the mesh wicks fit the coils rather than wrapping wire round the wicks.

It shouldn't, but can if it's borderline, a short will taste nasty (metallic) and you can see a short easily when dry pulsing, if you see one very short pulses and tweak the coil until you shift it.