Like easy RBA in KST mini - but not Subohming - suggestions?

[digicig]

OK so been away for a while (around 18 months ) and stumbled across the Kanger ST mini whilst in Ecuador of all places. Possibly the easiest RBA to build i've used.
Like the Vape quality - but tbh not the fierceness of the sub ohm thing - even if lung inhaling - plus the excesive juice use. I usually make a 1 Ohm coil and set at 3.6v.

The Anyvape Furytank - with the .6Ohm prebuilt coil was good but excessive for my preferences - i prefer a slightly tight (but only slight) long slow draw, rather than a fierce in ya face kind of vape.
That said, have a KFL etc and are more hassle than the KST - so looking for the ease of build and access to coil of the KST, with the Top Fill of the Furytank - that runs well at 1-1.5Ohms.

I'm looking for TEFL teaching work in Asia, where juice supply can be hard to find, so excessive juice use is best avoided - and blowing massive clouds may be frowned upon - and RBA a must.

So thought i'd ask the Kind Vapers of AAEC their opions/suggestions of the kit that's available.

Should also add that i'm not a dripping fan, and like a minimum 3-4ml tank.

Thanks in advance - Digicig

[phatfil]

kayfun squape, foggers and erls are all flavour intense atty's not tried an erl but the squape R,kayfun v4, and foggers are all very tasty vapes.
the foggers can be opened up wide for the clouds and subohming if you wish but also alow a tighter more 'traditional' vape.
I have yet to sus a non-leaking wick for the squape R..

all clones that i am on about

[drunkenbum]

The Lemo or Lemo drop might not be a bad shout

[Get Off My Cloud]

Quite the wishlist, not sure if there is anything which fits all the needs listed.
The Lemo 2 is an easy deck to build on, has good airflow adjustability and top filling but you can't access the deck without draining the tank.

[digicig]

Tis harder as i used to know (and had probably tried most ) of the new stuff that was about since 2010 - go away for a bit and suddenly someones shifted the goalposts LoL

Lemo2 does seem like an option - if i ever figure out the Furytank RBA that might be another. The 1st week i had the KST mini i went through around 100ml of juice - which won't be feasible as i'm looking to get a year contract this time. I suppose i could always try to get a job around Shenzhen - then it shouldn't be a problem