banditruss
Super Member
Joined:February 2015
Posts: 1,305 
Location:
Likes: 372
Recent Posts
Last Online Jan 24, 2018 19:18:07 GMT
|
Post by banditruss on Aug 11, 2015 15:46:21 GMT
hi all does anybody have a genuine bottom feed pin for the Origen v3 ?
if so please could you measure the height of where the cross feed hole is (i can drill up center then ,and then know where the feeder hols in pin should be )
thanks for any help russ
|
|
unclegromit
Super Member
Joined:June 2015
Posts: 741
Location:
Likes: 804
Recent Posts
Last Online Jun 30, 2023 15:43:32 GMT
|
Post by unclegromit on Aug 11, 2015 18:17:00 GMT
As best as I can measure it, ie. in situ, 13.5mm from the bottom.
|
|
banditruss
Super Member
Joined:February 2015
Posts: 1,305
Location:
Likes: 372
Recent Posts
Last Online Jan 24, 2018 19:18:07 GMT
|
Post by banditruss on Aug 11, 2015 18:24:39 GMT
thats great thanks alot mate  its a 1mm hole though isnt it ?,do you know if the top insulater is smaller than org to allow juice though ? cheers russ |
|
its a 1mm hole though isnt it ?,do you know if the top insulater is smaller than org to allow juice though ? cheers russ