Uwell Crown RBA leaks at times any idea's

[car147]

Bit of a strange one and probably down to manufacture, but when i am running one of the two Crown tanks i have it leaks occasionally for no apparent reason? it can be at any point whether the tank is full or low. One tank works fine the other has this issue, both were from FT.

I have tried differing wicking techniques, checked seals etc, etc. only thing i can put it down to is some machining issue, as it also does it also happens less often with the stock coils.


 

[car147]

Think I have found the issue, for some reason the RBA seems to be slackening off with use, tightened it more than usual and it has been fine since. I guess there must be some tolerance issue with the threading and the coil heating.

Happy as a pig in ****

[denzil]

Dec 8, 2015 13:21:07 GMT car147 said:

Bit of a strange one and probably down to manufacture, but when i am running one of the two Crown tanks i have it leaks occasionally for no apparent reason? it can be at any point whether the tank is full or low. One tank works fine the other has this issue, both were from FT.

I have tried differing wicking techniques, checked seals etc, etc. only thing i can put it down to is some machining issue, as it also does it also happens less often with the stock coils.


 

had similar issue with my ud goblin mini but it turned out to be my own fault, after I had my 1st attempt at wicking and installing new coils I didn't put any wick in the channels at the bottom and it was leaking straight out of them lol