Quick Lookie at the Anyvape FuryTank 2 - more to come later

[digicig]

Had an interesting visit to Anyvape today - Bill Tan is a very Enthusiastic guy, with some great ideas, who luckily speaks very good English.

I'd been trying to contact him for over a week, and eventually managed to get hold of him on the phone, and arrange today's 'interview'. I wasn't invited to tour the factory itself, as he said, he's been a trusted Aspire reseller for years and still isn't shown around - fair play.

As my timing was particularly fortuitous, Bill happened to have a couple of the new FuryTank 2's 'lying around' which he then gave to me to try
I was hoping i'd be able to buy one once there, so a very happy vaper

I received the original FT as part of Anyvape's FB give-away - which i posted here and on YT - the original head (with the 'scissor head' design) lasted me just over 6 weeks - strangely until the day after posting about how good it still was

The FuryTank 2 so far seems to do what it claims on the box:




I opened the Black FT2 - as i thought it would look good on the Reuleaux RX200 - which it does





Any Gappage on the pics between the Reuleaux and the FT2 are purely down to me trying to get the logo lined up for effect - the FT2 screws down flat

The Drip Tip is part of the 'Unique Twist Lock' top fill system - which means you can't use your favourite DT - so just as well i actually like this one then. Nice wide bore, nice and smooth curves and black anodised metal (possibly SS?). Didn't bring a measuring device, but if the manufacturer says 5ml - it rarely is - so possibly 4-5ml usable capacity. Very easy to fill - as it says on the box - to be on the safe side, close the AF, easy twist the DT and pull, and squeeze the juice in one of the 2 side slits; fill and twist the DT back on, open AF and vape I did do a test with the AF fully open and didn't notice a drop.


The AF is 4 slits, and, at least to begin with, is slightly stiff - not too bad as it means that it will stay where you set it, and if it does loosen up with use, then it shouldn't spin too freely. The AF is quite light fully open, so good for Lung hits and yet still OK for Mouth hits when closed down to below a third.

The Installed Clapton coil head - just Rocks! I haven't really begun to put it through its paces - reads 0.36Ohms on the Reuleaux and i had to stop at 70W's because of extreme nic hit (on 4mg juice) and some very 'miffed' Chinese soldiers, who weren't impressed by the sudden wall of fog being exhaled in their general direction. I'm currently staying at a mainly Chinese dormitory style hostel. It's cheap, actually quite nice, but the Owner, doesn't speak English, and although a smoker, doesn't seem to trust a device that can cloud up a room so swiftly as being 'safer than smoking' So experimentation since i've been 'home' has been limited to quick press, hold and try not to exhale! LoL

So far, gotta say i'm impressed - with the tank, the Top fill system, flavour and VP - will have a proper play over the next few days, before doing a proper write up and/or possible video

[digicig]

Had a better play today - the Clapton Coil can handle up to around 100W's before i noticed a very slight burny taste.
Being a mainly Mouth inhaler i prefer it at around 40W's with the AF open about a third of the way.

As one of the reasons i wanted to try the cCells was to try them in the FT2, i had to give it a go. Now the cCell is from the Target kit i bought here, and have been using for a couple of weeks - still good flavour and OK VP using the supplied Target tank.

Switched it into the FT2 and - the cCell's performance really goes up a notch

I've been mainly using the cCell at around 20W's on the Target mod, so dropped the FT2 + cCell on it at the same settings - and increased VP and i'd say improved flavour too. Some of this could be down to increased AF the Target tank having 2 cyclops compared to the FT2's 4, and the increased bore of the FT2's DT - which i'm really liking.

The FT2 is more than compatible with the cCells (now recategorised as 'safe' by Grimm Green and Vaporshark) - it actually seems to enhance them too

[digicig]

Day3
Staying at a 'proper hotel', rather than my dorm tonight, as i'm due to meet up with Kevin Chung from Joyetech US first thing in the morning - so no restrictions on vaping in me, increasingly foggy, room :cool:

Switched from the Reuleaux to the Target mod - easier and lighter to carry around - and it works very nicely. the coil is reading 0.37 on the Vaporesso compared to 0.39 on the Realeaux - which i'm more inclined to believe - so W's will adjust accordingly.

The DT is indeed a wide bore at the lips - but also, as it's an integral part of the 'Twist Lock' Topfill system - wider than usual at the base too by a few mm's - my KST DT easily fits inside and rattles around too. So no chance of fitting it to use on another device - even the Focalecig Genelocity DT is smaller

Was going to post pics - but phone, vpn and photobucket are squabbling at the mo

[blakey]

I hope the fury tank 2 is a decent tank
I bought the first incarnation and all I did was remove the rba section from the box to use in the xtank
The tank is still in there unused cos I didn't really like the look of it when I had it in my hands.

[smokingaces]

had a couple of anyvape tanks in the past were ok but nothing to write home about, will say the build quality was very good though,maybe will have a look at a fury2 tank.

[River]

lovin the 1st fury tank......fitted with a 0.3ohm triton coil......happy days