Need a decent mouth to lung atty

[quincey43]

Feb 8, 2017 16:54:20 GMT silvasurfa said:

Feb 8, 2017 16:31:26 GMT quincey43 said:

I've seen this mentioned before, is it really a good MTL tank, looks interesting!!

yes, there is a review here:-

Silva

Looks good and after seeing the new Nautilus looks even better!! Think I might be tempted.

[DaveJ]

Feb 8, 2017 15:48:15 GMT pyr0 said:

Kayfun Lites are still my go-to MTL tanks
I pretty much gave up buying tanks because I found them all to be rubbish compared to the old KFL/+
Fairly recently I've gotten a Spheroid v4 and I've picked up a kayfun mini v3 which isn't bad (but still a waste of £)..
but I still prefer the vape from the older Kayfuns.. I just wish you could access the coils easier after filling.

I gained the impression, perhaps incorrectly, the OP was not after rebuidable stuff.

BUT I have this exact same opinion. Whilst I've not tried lots of different atties, I've yet to find anything that gives me a vape I enjoy as much as my FT Kayfun Lites.

Granted - I had to monster their juice channels to handle thicker juices and the downsides you observed are valid (need a screwdriver to refill, can't easily work on the coil without draining the tank) but even so, they "do it" for me.

[Pepperty]

Feb 8, 2017 21:38:19 GMT quincey43 said:

Feb 8, 2017 16:54:20 GMT silvasurfa said:

yes, there is a review here:-

Silva

Looks good and after seeing the new Nautilus looks even better!! Think I might be tempted.

I have this tank, its very well made and although its 19mm it tapers out and holds 4ml and the coils last an absolute age, I think the pair that came with the astral lasted me almost 6 weeks (each one) 

BUT the only supplier of coils that I can find worldwide is iVapour (Ireland) and cost £2.95 per coil  and although the tanks are available at fasttech for around £8 they dont sell the coils, in fact I cant find coils sold at SBody either. Its a terrible shame as the atomiser is lovely and designed for my sbody elfins (no overhang, but great capacity) I really love this atty and would happily buy 3 or 4 but cant bring myself to pay almost £3 a coil.   and from what Ive read online they dont appear to be rebuildable? --- but I will take the pliers to one and see...

[alice85re]

Kabuki, uses nautilus coils. MTL tank.
£8
m.fasttech.com/p/3870800

Or depending on budget:
www.cremedevape.com/epages/yxve46fvrnud.sf/en_GB/?ObjectPath=/Shops/yxve46fvrnud/Products/HOH-45

[HaroldTheBarrel]

How about the Triton Mini. It uses Nautilus coils, top fill, huge airflow adjustment range and better flavour than the Nautilus.

I carry one around in my pocket at work on top of an Istick Pico as my stealth vape and I've never had a leak.

[sydsut]

Feb 9, 2017 20:33:52 GMT HaroldTheBarrel said:

How about the Triton Mini. It uses Nautilus coils, top fill, huge airflow adjustment range and better flavour than the Nautilus.

I carry one around in my pocket at work on top of an Istick Pico as my stealth vape and I've never had a leak.

I expect that a visit to your doctor should put that right

[domesticextremist]

Feb 8, 2017 21:37:19 GMT djs said:

Feb 8, 2017 19:42:15 GMT domesticextremist said:

Ta, I'm becoming sorely tempted - I see the 16.5mm version for just £9 and understand the heads are a doddle to recoil (just as well 'cos they ain't cheap)

For you, yes ('coz you are good at it)...

For me, the bin wins.

If I'm going to 'build' I build on RTAs.

(Although I do rebuild CLR coils)

So I got one, with 1.5 Ohm coils. Not bad at all for flavour and performance, though a bit low resistance for an iStick 20W.
Will e recoiling as 1.8 single coil and if I do it right, my be able to dispense with the silicone airflow thingy.

Apologies to OP for minorly hijacking the thread.

[HaroldTheBarrel]

Feb 10, 2017 2:06:01 GMT sydsut said:

Feb 9, 2017 20:33:52 GMT HaroldTheBarrel said:

How about the Triton Mini. It uses Nautilus coils, top fill, huge airflow adjustment range and better flavour than the Nautilus.

I carry one around in my pocket at work on top of an Istick Pico as my stealth vape and I've never had a leak.

I expect that a visit to your doctor should put that right

Old Father Time is already doing that, especially at night 🤓

[scaffman69]

I can`t coil atties so they have to be pre-made coil type atties. But yes i ended up ordering a few gs air m 19mm tanks, 1.2ohm and a few kabuki clones i like these but my last one broke too easy, but the new steel`ier looking tank look ok, lets hops so, i also ordered a replacement bottom for my nautiluis, i`m wondering do triton coils fit the kabuki clones as well ?

Cheers for all your replies guys, plenty to sift through their for me.

[silvasurfa]

Feb 12, 2017 13:58:35 GMT scaffman69 said:

I can`t coil atties so they have to be pre-made coil type atties. But yes i ended up ordering a few gs air m 19mm tanks, 1.2ohm and a few kabuki clones i like these but my last one broke too easy, but the new steel`ier looking tank look ok, lets hops so, i also ordered a replacement bottom for my nautiluis, i`m wondering do triton coils fit the kabuki clones as well ?

Cheers for all your replies guys, plenty to sift through their for me.

Triton Mini and normal Nautilus coils should be Ok, but not the full size Triton coils which are different.....
Silva