Kayfun filling screws needed

[piper1]

Hi where can i buy replacement Kayfun filling screws from?

Thank you
piper1

[pacman]

Can't remember the size it was but always used boltbase on eBay for them.

[pacman]

Will have a look tonight and see if I have some knocking about

[piper1]

Sept 28, 2017 10:47:19 GMT pacman said:

Will have a look tonight and see if I have some knocking about

Thank you very much.

Ta
Kev

[VapingBad]

IIRC m2.5 counter sunk, 90% sure

[goneforagasper]

   SCREWS


      Deck screws: M1.6 x 0.3mm

     Fill hole screws:
     Kayfun Lite: M2.5 Countersunk, length = 4mm (use this if the screw sits flush at the base).
     KFL+ : M2.5 Pan head, length = 4mm (use this if the screw is a round head and recessed in the hole).


       I find that going with 5mm length is better - less leakage

[VapingBad]

A little bit of PTFE tape on the screw as close to the head as possible stops leaks.

[piper1]

Thank you for the replies great help.

[pacman]

Sept 28, 2017 19:18:48 GMT piper1 said:

Thank you for the replies great help.

Found a new one  for you also put an oring on it .Will send you a couple of nylon screws as well as I found these to be good if you had leakage issues.You just need to cut them to length.

Pm me your address and I will post it out to you tomorrow. (The wife will is what I meant so say)  

[phtumshk]

Have a look for a kayfil tool, handy little gadget for filling yo K-fun.

[piper1]

Sept 28, 2017 20:48:16 GMT phtumshk said:

Have a look for a kayfil tool, handy little gadget for filling yo K-fun.

That looks pretty interesting, thank you.

[phtumshk]

Sept 28, 2017 21:07:49 GMT piper1 said:

Sept 28, 2017 20:48:16 GMT phtumshk said:

Have a look for a kayfil tool, handy little gadget for filling yo K-fun.

That looks pretty interesting, thank you.

Must point out it doesnt work with all clone kayfuns depending on the cap/chimney but does work with all the originals.
Ive got a clone kayfil here you can have if you still use your Kfuns regular.
I dont really need it as I glued all me chimneys to the top caps so I can just unscrew the base like a subtank.

[piper1]

Sept 28, 2017 21:31:07 GMT phtumshk said:

Sept 28, 2017 21:07:49 GMT piper1 said:

That looks pretty interesting, thank you.

Must point out it doesnt work with all clone kayfuns depending on the cap/chimney but does work with all the originals.
Ive got a clone kayfil here you can have if you still use your Kfuns regular.
I dont really need it as I glued all me chimneys to the top caps so I can just unscrew the base like a subtank.

Thank you for the offer but to be honest i don't think i would use it that much.

Ta
Kev