Need more tanks

[doveman]

I've mainly been using my Wotofo Serpent RTA for vaping non-CBD juices and that's fine but I really need one or two more for CBD juices as well.

I didn't really get on with my Squonk mod and Wasp Nano RDA but I'm using it to drip test my CBD juices, which it's handy for and I can easily change the wick between juices.

I've also got a Crius OBS RTA but that has a terrible problem with crackling/spitting, even if I close the feed holes to try and stop the coil flooding. I noticed that even with the holes closed the level in the tank goes down anyway over time, so it must be getting to the coil by some other route. It's also a hassle having to wick two coils and I don't really see any benefit.

What I do like about the Serpent and the Crius is that I don't think they've ever leaked on me. Whether that's because the feed and air holes can both be closed off, which I tend to do if they're going to be in my pocket for a while, or something else I don't know. My Subtank RBA is a terrible leaker though. I haven't used it much recently and when I found it the other day it was lying in a puddle of juice it had leaked! It's a shame as I bought a large replacement pyrex part for it which holds enough to last me a day of heavy use.

So to sum up, I need a couple of different-looking tanks (different colours would probably be best so that I can put different CBD juices in them and easily remember which is which), which are single-coil, don't leak, don't make strange noises and allow me to close off the feed.

I should probably get another box mod as well, so I can leave the non-CBD tank on one and use that most of the time and grab the other one with the CBD tank on it from time to time. Besides, it's always good to have a spare. I want something fairly compact that will fit in my jeans pocket and takes a 18650 battery. I only tend to vape at around 10w, partly because I don't notice any benefit from vaping at higher in terms of clouds and it reduces the battery life and increases the chance of burnt taste, but also with CBD I think high temperatures might damage it anyway, so it's safer to keep it low. So let me know if you've got any suggestions that would be suitable please.

[decoy]

how do you vape
big clouds or little ones lol

[doveman]

Oct 12, 2018 17:27:37 GMT decoy said:

how do you vape
big clouds or little ones lol

Very much little. I don't know why but even if I turn my mod up from 10w to 40w it doesn't seem to make much difference to the cloud volume and it starts to taste burnt if I go much higher and still doesn't seem to make much difference to the cloud. I don't really care though, it's less hassle vaping in public when I'm not producing big clouds and I don't want to waste my CBD in clouds. That stuff's expensive!

I'm using 70/30 PG/VG with the CBD as it needs high PG to dissolve properly but I've used 50/50 with non-CBD juices and can't say it made much difference to the clouds I was producing either. Certainly my friends seem to produce much thicker clouds. Not that I care 

[decoy]

tbh most coils will spit and crackle when new but settle down after a tank or 2 spaced coils less so
if you only running at 10 watts then a mtl tank like the doggy style clone might be worth a look for your cbd
i use 0.3mm ss wire to make simple mtl coils as you dont need anything fancy and you can get a 1 ohm coil with out to much fuss

for you obs and serpent you could use thicker wire or lower ohm coils to get the big clouds if you want them
the lower the ohms the bigger the cloud to a point
also you wicking needs to be right for the higher powers ie if you get dry hits then use less cotton and if it leeks use more lol